This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, an...
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch...
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Dustin
January 24, 2023
Replaced heating element but still isn't drying properly. Is there a fan motor that needs to be replaced or is the controls/sensors not working?
For model number WED7500VW2
Hi Dustin, thank you for asking. If replacing the heating element did not help, we suggest that you check the three thermostats in the dryer if they are working and inspect the lint filter for any blockage. If you require assistance to place an order, please contact customer service. We hope that helps!
Isn't drying! Replaced heating element but still isn't working properly. Is there a fan motor that needs to be replaced? Or something else?
For model number WED7500VW2
Hello Dustin, thank you for reaching out. According to our research, we would recommend checking the Blower Motor, part number PS11744999. If that does not help, we would suggest checking the Control Panel, part number PS2348879. Please reach out to customer service if you need help placing an order, anyone will be happy to assist you. We hope that helps.
This product comes in a bottle with a brush like Liquid Paper. It goes on incredibly easy. A second coat might be needed. I wanted to prevent rust from setting in so I covered the scratches and dings. The paint is a little brighter since my washer is 10 years old but it still looks great.
First, I unplugged the dryer. The Power button itself can be removed by grasping it in your fingers and pulling strait forward. There is also a rubber gasket between the button and switch, so hang onto that. To access the area behind the power button I needed to remove the top of the dryer. It is held in place by two torx screws on either side at the back. Luckily I have a stubby screwdriver with interchangeable heads which includes two torx drivers. I used the T15 size and it worked, although I couldn't say if that is the exact size of the screw head. After removing the dryer top, I could see that behind the three push buttons (Power, Temperature, Start) are the respective Switches. Checking the schematic on Parts Select, I ordered the Power Switch. When I got it, I swapped out the old for the new one. There are four blade type connections which I did one at a time so as to get it hooked up the right way. Then guide the switch into the hole on the front panel and push the gasket and button onto it from the front. Replace the top temporarily and plug the cord back in to test it. It works! Then I replaced the torx screws to tighten down the top. The 'bit of difficulty' I had was in accessing the screws at the back as this is a compact, stackable washer and dryer which is located in a closet.
