This wheel is a dishwasher rack wheel designed for the upper rack of your appliance. The roller wheel is approximately 1.25 inches in diameters and includes the brushing you need for installation. It ...
This dishwasher door gasket creates a watertight seal between the door and the tub, preventing leaks during wash cycles. Made from flexible black rubber, it fits securely along the edge of the door to...
If your dishwasher isn’t filling with water, running dry, or leaking, the water inlet valve might be the issue. This part controls how much water flows into your dishwasher during each cycle. It’s des...
Ensure proper detergent release during wash cycles with this genuine latch kit, designed to open the detergent cup at the right time and prevent premature opening. The kit includes a latch, spring, an...
Keep your silverware neat and clean with this Bosch dishwasher basket. It fits in the lower rack and has separate sections for utensils plus a handy handle for easy removal. Made from sturdy plastic, ...
This float switch is a replacement sensing component designed to detect water levels and prevent overflow conditions. It helps regulate operation safely and is commonly replaced when switches stick, f...
We let this go for a shameful amount of time before I decided I could probably fix it. The roller broke so you could only pull it out about halfway or it would come off the track. I looked up the part, and bought it. Actually bought two in case it happened again. When I arrived I looked at how it was put together on the other side and then just basically pushed it onto the rod and it was fixed. I am ashamed it took so long to do it. Never be afraid to try it yourself. It was a total of $10 shipped to fix it.
REMOVED DISHWASHER FROM CABINET. DETACHED BASE FROM BODY OF THE DISHWASHER. INSTALLED NEW CORD, REATTACHED BASE TO BODY OF DISHWASHER AND REINSTALLED IN CABINET. OPINION: THIS IS A LENGTHY REPAIR AND UNNECESSARY ONE. THE CORD IS PART OF THE DOOR COUNTERWEIGHT AND SUBJECT TO TENSION EVERY TIME THE DOOR IS OPENED, AS WELL AS POTENTIAL CHAFFING DUE TO PROXIMITY TO VARIOUS METAL PARTS, AND VIBRATION. THE CORD SHOULD BE MADE OF STRONGER MATERIAL AND ARMORED OR ALLOWED MORE CLEARANCE. BOSCH SHOULD FIX TO LAST THE LIFE OF THE DISHWASHER.
Turn off power to unit! -Remove kick panel,2 screws. -remove water valve, 2 screws, 3 electrical connections, 1 hose clamp. -Remove elbow from old valve and install on the new valve ( use teflon pipe tape) -replace valve, hose & hose clamp, electrical connectors and water supply line. Scew unit in place ,2 screws. Check for leaks then replace kick panel, 2 screws.
