This dishwasher water inlet valve is a genuine replacement component engineered to regulate water flow into the appliance, ensuring accurate fill levels for optimal cleaning performance. Constructed t...
If your dishwasher isn’t cleaning well, won’t start, or is leaking, this heat pump assembly could be the fix. It’s designed to fit select Bosch, Thermador, and Gaggenau models and helps circulate and ...
This drain pump is designed for use in various dishwasher models and is responsible for efficiently removing water at the end of each cycle. It directs the water through the drain hose, which connects...
Keep your dishwasher or refrigerator draining properly with this replacement drain hose. It helps move used water out of the appliance and into your home’s plumbing system, preventing puddles and left...
If your dishwasher is leaking or not draining properly, this replacement drain hose might be the fix. It connects the dishwasher to your sink drain or garbage disposal, carrying away dirty water after...
This door lock assembly helps keep your dishwasher door securely closed during each cycle. It prevents leaks and ensures the appliance operates safely and efficiently. If your dishwasher won’t start, ...
Is your dishwasher not cleaning your plates and glasses as flawlessly as it used to? This could be due to a faulty spray arm. Fear not, as we bring to you Bosch's genuine spray arm, a top-grade part t...
If your dishwasher isn’t releasing detergent or rinse aid, this dispenser might be the fix. It holds both cleaning agents and releases them at the right time during the cycle. Easy to install and made...
If your dishwasher isn’t draining right, making strange noises, or leaving dishes dirty, the sump might be the problem. This part sits under the tub and helps move water through the system while catch...
Keep your dishwasher running safely with this door switch. It makes sure the door is closed before the cycle begins, preventing leaks and start-up problems. If your dishwasher won’t start or the latch...
$54.69
In Stock
Questions And Answers for SHE3AR75UC
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
This was the third time I replaced a fill valve in a Bosch diswasher, twice in this unit and once in a previous unit. I read the installation hints on your web site and want to add the following suggestion.
The notes on your web site say you can remove the valve from behind the toe face and pull it out to reach the hose and plug. I found that the Bosch designers called for both the hose and wire to on the short side. I found that pulling the dishwasher forward 6" to 9" allows you to access these connections from the side at least to hold them while making the connection. I hope this helps. Thank you, Bill
Turn off water, disconnect power cord, remove front kickplate. Remove 2 screws that hold the water inlet valve, pull it out, disconnect electrical connection, disconnect water supply.. Check the inlet valve with volt-ohm meter for continuity. If it is good, then the valve is stuck shut. The ohm reading should be in the 900-1100 range. Replace valve, installation is the reverse.
disconnected inlet hose and water line from sink, removed old inlet valve and installed new valve and reconnected inlet hose and water line from sink - checked for leaks.
