This wheel is a dishwasher rack wheel designed for the upper rack of your appliance. The roller wheel is approximately 1.25 inches in diameters and includes the brushing you need for installation. It ...
This dishwasher water inlet valve is a genuine replacement component engineered to regulate water flow into the appliance, ensuring accurate fill levels for optimal cleaning performance. Constructed t...
This wheel for the lower rack of your dishwasher, it includes the brushing you will need for installation; the axel is not included. You need to line the replacement wheel up with the axel, slide it i...
This replacement micro filter is designed to trap small food particles and debris during the wash and rinse cycles, helping to maintain optimal cleaning performance in your dishwasher. Positioned with...
If you’re seeing water puddles near your dishwasher or noticing louder wash cycles, the bottom door seal might be worn out. This part keeps water and steam inside during a wash and helps your dishwash...
Keep your dishwasher or refrigerator draining properly with this replacement drain hose. It helps move used water out of the appliance and into your home’s plumbing system, preventing puddles and left...
If your dishwasher is leaking or not draining properly, this replacement drain hose might be the fix. It connects the dishwasher to your sink drain or garbage disposal, carrying away dirty water after...
Having trouble with your dishwasher? Let's help you solve that with the Bosch Dishrack Tine Row Holder. This is an original, high-quality part that helps your dishwasher work at full efficiency by sec...
If your dishwasher isn’t draining properly, this drain pump cover might be the part you need. It helps guide water from the bottom of the dishwasher to the drain pump so everything flows smoothly. Mad...
This gray plastic clip helps keep your dishwasher’s lower rack organized by holding the adjustable tines in place. It makes it easier to fit different dish sizes and keeps everything steady during the...
$10.09
In Stock
Questions And Answers for SHE3AR75UC
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
We let this go for a shameful amount of time before I decided I could probably fix it. The roller broke so you could only pull it out about halfway or it would come off the track. I looked up the part, and bought it. Actually bought two in case it happened again. When I arrived I looked at how it was put together on the other side and then just basically pushed it onto the rod and it was fixed. I am ashamed it took so long to do it. Never be afraid to try it yourself. It was a total of $10 shipped to fix it.
This was the third time I replaced a fill valve in a Bosch diswasher, twice in this unit and once in a previous unit. I read the installation hints on your web site and want to add the following suggestion.
The notes on your web site say you can remove the valve from behind the toe face and pull it out to reach the hose and plug. I found that the Bosch designers called for both the hose and wire to on the short side. I found that pulling the dishwasher forward 6" to 9" allows you to access these connections from the side at least to hold them while making the connection. I hope this helps. Thank you, Bill
Turn off water, disconnect power cord, remove front kickplate. Remove 2 screws that hold the water inlet valve, pull it out, disconnect electrical connection, disconnect water supply.. Check the inlet valve with volt-ohm meter for continuity. If it is good, then the valve is stuck shut. The ohm reading should be in the 900-1100 range. Replace valve, installation is the reverse.
