Ask our experts a question about this model and we'll get back to you as soon as possible!
4 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Vivian
September 15, 2022
The water will not drain.
For model number SHE3AR56UC/07
Hello Vivian, thank you for your inquiry. Our research on your model number suggests that the issue is likely to be with the Drain Pump, part number PS8727352. Customer service is always available to help you place an order if you are having trouble doing so. Good luck with your repair!
Switches to clean a minute and a half after pressing the start button
For model number SHE3AR56UC/07
Hello Gregory, thank you for your inquiry. According to our research, there seems to be an error with the user interface control board, part number PS8736204. You may need to replace it to resolve the issue. We hope this solves your problem!
What could cause the dishwasher to suddenly get no power. I have checked the circuit and power is getting to the machine but there are no lights on the control panel it just seems dead.
For model number SHE3AR56UC/07
Hello Jim, thank you for reaching out. Based on our research, we would recommend checking the control board, part number PS8736204, to fix the issue. We hope this solves your problem!
Hello Kathy, thank you for contacting us. According to our understanding, we would recommend checking the wire harness of the user interface board for any fault. If the wire harness is fine, then the issue is most probably with the control unit, part number PS8736204. You may need to replace it to solve the problem. Glad to be of assistance!
We let this go for a shameful amount of time before I decided I could probably fix it. The roller broke so you could only pull it out about halfway or it would come off the track. I looked up the part, and bought it. Actually bought two in case it happened again. When I arrived I looked at how it was put together on the other side and then just basically pushed it onto the rod and it was fixed. I am ashamed it took so long to do it. Never be afraid to try it yourself. It was a total of $10 shipped to fix it.
disconnected inlet hose and water line from sink, removed old inlet valve and installed new valve and reconnected inlet hose and water line from sink - checked for leaks.
This was the third time I replaced a fill valve in a Bosch diswasher, twice in this unit and once in a previous unit. I read the installation hints on your web site and want to add the following suggestion.
The notes on your web site say you can remove the valve from behind the toe face and pull it out to reach the hose and plug. I found that the Bosch designers called for both the hose and wire to on the short side. I found that pulling the dishwasher forward 6" to 9" allows you to access these connections from the side at least to hold them while making the connection. I hope this helps. Thank you, Bill