SGCS304RS Thermador - Overview

Models starting with SGCS304RS

Keep searches simple, eg. "belt" or "pump".
SPACER – Part Number: 00413552
SPACER
★★★★★
★★★★★
(1)
PartSelect #: PS8709371
Manufacturer #: 00413552
$43.27
  In Stock
IGNITION HEAD – Part Number: 00189324
IGNITION HEAD
PartSelect #: PS8698440
Manufacturer #: 00189324
$89.01
  In Stock
VALVE – Part Number: 00411253
VALVE
★★★★★
★★★★★
(2)
PartSelect #: PS8707103
Manufacturer #: 00411253
This valve controls the flow of water or gas into the appliance, opening and closing as needed for proper operation. Reliable valve performance supports efficiency and leak prevention. Replacing a mal...
$354.22
  In Stock
LENS – Part Number: 00189343
LENS
★★★★★
★★★★★
(1)
PartSelect #: PS8698456
Manufacturer #: 00189343
$20.89
  In Stock
Spark Igniter Switch – Part Number: 00189008
Spark Igniter Switch
PartSelect #: PS8698334
Manufacturer #: 00189008
Sold individually.
$60.94
  In Stock
NUT – Part Number: 00188978
NUT
PartSelect #: PS8698313
Manufacturer #: 00188978
$32.76
  In Stock
RING – Part Number: 00189322
RING
PartSelect #: PS8698438
Manufacturer #: 00189322
$15.32
  In Stock
Spark Module – Part Number: 00753257
Spark Module
★★★★★
★★★★★
(1)
PartSelect #: PS8737287
Manufacturer #: 00753257
$298.09
  In Stock
SEAL – Part Number: 00189317
SEAL
PartSelect #: PS8698434
Manufacturer #: 00189317
$35.31
  In Stock
SEAL – Part Number: 00189320
SEAL
★★★★★
★★★★★
(1)
PartSelect #: PS8698436
Manufacturer #: 00189320
$12.29
  In Stock
Cooktop Burner Cap – Part Number: 00189336
Cooktop Burner Cap
★★★★★
★★★★★
(1)
PartSelect #: PS8698452
Manufacturer #: 00189336
Sold individually. This burner cap is for cooktops. Burner cap fits on top of the burner head. The burner cap protects the burner head from spills and helps spread out the burner flame for even heating.
$115.78
  In Stock
HOLDER – Part Number: 00414785
HOLDER
PartSelect #: PS8710583
Manufacturer #: 00414785
$103.89
  In Stock
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
the lens did not fit It did not fit in the hole of the range top
I has to file the bottom edge on a slight angle so the lens would fit in the hole. Also I had to file the top edge cause it had little tabs and and also had to file the edge below the top of the lens then it would snap in so I have to say the woman I talked to said she guaranteed me it would fit and it didn't
Parts Used:
LENS
  • richard from HOPATCONG, NJ
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
1 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!