RJGR3663A Maytag Cooktop - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Oven ignition switch failed
This is actually for a Dynasty (Jade) Range (but that's not an option in the selection).
The repair is very easy - after you shut power off to the stove.
1. Remove all the stove control knobs from the front panel.
2. Remove the 2 phillips head screws on either side of the front control panel.
3. Pull the front panel out about 3 inches to expose the back of the switch.
4. Use a flat head screwdriver to push the retention clips down and loosen the switch from the panel.
5. Move the 5 wires connected to the switch using pliers, one by one to the new switch.
6. Push the new switch into the panel.
7. Replace the panel and controls.
8. Restore power and test.
The repair is very easy - after you shut power off to the stove.
1. Remove all the stove control knobs from the front panel.
2. Remove the 2 phillips head screws on either side of the front control panel.
3. Pull the front panel out about 3 inches to expose the back of the switch.
4. Use a flat head screwdriver to push the retention clips down and loosen the switch from the panel.
5. Move the 5 wires connected to the switch using pliers, one by one to the new switch.
6. Push the new switch into the panel.
7. Replace the panel and controls.
8. Restore power and test.
Parts Used:
-
Leon from San Francisco, CA
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers, Screw drivers
3 of 4 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!