RJGR3661A Maytag Smoker - Overview
Sections of the RJGR3661A
[Viewing 4 of 4]
Keep searches simple, eg. "belt" or "pump".
2 Piece Broiler Pan
PartSelect #: PS971245
Manufacturer #: 4396923
The top of this part is now black.
$59.89
In Stock
Order within the next 11 hrs and your part ships today!
Stainless Steel Cleaner
PartSelect #: PS2360188
Manufacturer #: 31462A
Use this bottle of stainless steel cleaner and polish for any of your stainless steel appliances.
No Longer Available
Oven Igniter
PartSelect #: PS2074089
Manufacturer #: 70001036
This part is used to light the oven for the bake or broil.
No Longer Available
NOT REQUIRED PART OR SEE NOTE
PartSelect #: PS12535753
Manufacturer #: W10124350
No Longer Available
Questions And Answers for RJGR3661A
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Purchased home but stove had no broiler pan.
-
Raymond from BLOOMINGTON, MN
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
16 of 31 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Oven ignition switch failed
This is actually for a Dynasty (Jade) Range (but that's not an option in the selection).
The repair is very easy - after you shut power off to the stove.
1. Remove all the stove control knobs from the front panel.
2. Remove the 2 phillips head screws on either side of the front control panel.
3. Pull the front panel out about 3 inches to expose the back of the switch.
4. Use a flat head screwdriver to push the retention clips down and loosen the switch from the panel.
5. Move the 5 wires connected to the switch using pliers, one by one to the new switch.
6. Push the new switch into the panel.
7. Replace the panel and controls.
8. Restore power and test.
The repair is very easy - after you shut power off to the stove.
1. Remove all the stove control knobs from the front panel.
2. Remove the 2 phillips head screws on either side of the front control panel.
3. Pull the front panel out about 3 inches to expose the back of the switch.
4. Use a flat head screwdriver to push the retention clips down and loosen the switch from the panel.
5. Move the 5 wires connected to the switch using pliers, one by one to the new switch.
6. Push the new switch into the panel.
7. Replace the panel and controls.
8. Restore power and test.
Parts Used:
-
Leon from San Francisco, CA
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers, Screw drivers
3 of 4 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
broiler pan missing
-
RAYMOND from JACKSONVILLE, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
1 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!