RGH846GEJ2 Hotpoint Range - Instructions

Unplugged the appliance for safety. Removed two 1/4" screws that held the assembly in place. Carefully removed the wire guard that retains the glass shield. Unscrewed old light bulb and replaced with new part. Reversed the steps after cleaning glass cover.

Took amp reading, which was 2.5 amps, that identified that the igniter needed to be replaced, for the safety valve requires 3.2 amps or better. Replaced, and everything is okay.

I had to call for a appointment for repair with GE Appliance because I thought then it . .was something electrical. The technician came out & checked everything out, turned out it was not electrical, The technician went out to his truck got a light bulb from his truck, put it in & it worked. It cost me $121.00 for trip charge from GE appliance for a light bulb that worked, your light bulbs were defective twice. Very disappointed with your products, cost me alot of money for a good light bulb thru GE appliance

No problem getting to igniter in oven to remove from holder. Difficult to disconnect igniter at rear after removing drawer. Just hard to get to. Broke one of the plug-in receivers so had to crimp on a new one. This was a hinged pair that received the igniter lead and another lead that went to another part.

First wrote a wiring diagram then disconnected old igniter by removing two screws and unplugging.
Then just reversed the whole operation.
However, it never worked because the "oven/broiler" switch broke.
Its time for a new stove.
But I would recommend PartsSelect to anybody.
Your selection is great, you shipped as promised, and the best part was the price.

Ordered new igniter switch, but Fedex lost it! Partselect sent new one overnight. Really a cinch to install. Be sure to unplug oven or turn off breaker if you are not comfortable with working with live electrical wires!

replaced lights in refrigirator and freezer

0. As a safety precaution, unplug the range or hit the relevant fuse breaker before you start. You might also want to grab a flashlight. Definitely do not try to do this while the oven is hot.
1. Pinch the wire over the light bulb cap to remove it. This is inside the oven at the back.
2. Pop off the hemispherical glass cap.
3. Unscrew the old light bulb, and screw the new light bulb in its place.
4. Put the cap back.
5. Secure the cap by putting the wire back in its slots on the cap.

No tools needed, the cap is just held in place with pressure from the wire.

Turned the wire protector to the side. Turned out the old bulb and replaced it with the new. Turned the wire protector back in place and I'm like new.

Easy

Pulled the knob's off the front of the stove. Removed 7 phillps screws holding on the front plate, pulled off the front plate, removed the ignitenr, and then reassembed the stove. It worked great.

Removed old ignighter and replaced it with the new one. No brainier. Took longer to find the correct part, mine had three wires, most are just two.

I just had to lift the top of the stove. Then pull the old burners out and put the new ones. It took longer to ignite the flame than replace the burner. Works great !!!