This economic nut is a manufacturer-approved replacement part for your oven range. The nut can become worn down or stripped over time and need replacing. Make sure to disconnect power to the unit and ...
Having trouble with spills on your GE cooktop? You might need a new Control Panel Seal. This part is a crucial player in keeping those accidental spills from sneaking under the control panel where the...
Purchased another Cooktop Control Knob assembly and pulled the old knob off carefully and replaced with the new Control Knob Assembly. It was very easy and quick ! Thanks FB
The following are steps in replacing a burner electrode for GE Profile Cook Top Model PGP7030DL1BB 1. Shut off gas and unplug electrical plug 2. Remove all stove grates and turn on knobs 3. Remove all burner covers 4. Remove all screws [three for each burner] 5. Remove two screws near front by removing rubber grate grommets 6. Carefully Lift off stove cover and set aside 7. Remove shield near back of stove top. This exposes all burner wires 8. Remove electrode to burner which does not lite by sliding out clip at bottom of electrode—note color code of wire and replace with same. Change one electrode at a time to insure wire color code is correct. 9. Reassemble in reverse order of steps 1-8
The knobs arrived beautifully packed and fit perfectly. They needed replaced because I had put old ones in top rack of dishwasher and the finish, which is some kind of foil like paper, peeled off. I have always put knobs in dishwasher and never had a problem
