This OEM-compatible screw is designed for use with many GE dishwashers. Measuring 8-16 HXW and 1/2" in length, this stainless steel screw secures the middle spray arm hub to the upper rack assembly, e...
Fix a freezer door that won’t close properly with this genuine spring hinge mullion. It keeps the flipper seal tight, preventing warm air from entering and helping maintain the right temperature. If y...
This LED light and cover assembly is designed for the fresh food compartment of compatible refrigerators, providing bright, energy-efficient illumination to help you easily see and access stored items...
If your fridge is building up too much frost or not cooling evenly, this defrost thermostat might be the issue. It helps control the temperature during the defrost cycle by shutting off the heater whe...
I went to a GE repair center to explain my problem, the service center reccomended that I have a techinician come out o look at it. $75.00 for the visit and what ever labor and materials wuld cost.
I went on line to see if there were others having this same problem and found that there were many with the same problem.
After reading some of the ways that people found out what was wrong ...it became a matter of three components, the timer, heater or thermostat.
I tried the most common component and the less expensive one first , the thermostat switch I installed it very easily snipping two wires and attaching the news using wire nuts I used the diagram on this website to pinpoint the component and there has not been a problem since.
went to your website and viewed exploded view to find the sensor( there are two I just picked one to replace for now), pried the cover off carfully and pulled out the sensor. I snipped the wire in the middle leaving plenty to work with. I shortened the wire on the new piece, spliced the wires together and with some 3M rubberized, tape wrapped them up, replaced the sensor back into the cover and snapped in place.
