This NSF-certified refrigerator water filter is engineered to improve the taste, clarity, and safety of your drinking water by reducing contaminants such as mercury, lead, and trace pharmaceuticals. D...
The interior light of your refrigerator is controlled by a switch that is activated when the door is opened and closed. If your refrigerator light will not turn on, there could be an issue with the sw...
This OEM-compatible screw is designed for use with many GE dishwashers. Measuring 8-16 HXW and 1/2" in length, this stainless steel screw secures the middle spray arm hub to the upper rack assembly, e...
This is a door handle fastener to secure the handle to your refrigerator drawer. It is also known and a mounting bolt or screw. It is approximately 1 inch in total length, and is made of metal.
Keep your refrigerator’s crisper drawer in top condition with this replacement vegetable pan glass. It offers a clear, durable surface for storing fruits and vegetables, and fits securely above the dr...
Is your GE refrigerator in need of a little repair? Our Left Hand Ice Door Mid Bin is just what you need. Designed specifically for GE refrigerators, this sturdy bin fits neatly inside your refrigerat...
If your fridge is building up too much frost or not cooling evenly, this defrost thermostat might be the issue. It helps control the temperature during the defrost cycle by shutting off the heater whe...
Need to get your refrigerator back to its best? Our GE Latch Icebox Door is the duty called upon to assist. This small but mighty part is specifically tailored for GE refrigerators, ensuring the secur...
This OEM part is from GE and is designed for use in your refrigerator. This part is known as a door mounting screw, and is for mounting the handles of the refrigerator to the door studs.
If your fridge is frosting up or not cooling like it should, this defrost heater might be the issue. It melts ice off the coils so your fridge can stay cool and run efficiently. It’s a genuine replace...
$71.48
Special Order
Questions And Answers for PFD28KBLJTS
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
I went to a GE repair center to explain my problem, the service center reccomended that I have a techinician come out o look at it. $75.00 for the visit and what ever labor and materials wuld cost.
I went on line to see if there were others having this same problem and found that there were many with the same problem.
After reading some of the ways that people found out what was wrong ...it became a matter of three components, the timer, heater or thermostat.
I tried the most common component and the less expensive one first , the thermostat switch I installed it very easily snipping two wires and attaching the news using wire nuts I used the diagram on this website to pinpoint the component and there has not been a problem since.
I applied some tips learned by reading other reviews. So before I started I grabbed my trusty vise grip pliers and a small screw driver. I locked onto the switch actuator, the part that the refrigerator door pushes in, with the vise grips and pulled on it just hard enough to get the screw driver inserted in the right side to push in the catch clip so the switch could be pulled out further each time the catch clip was depressed to the next detent. Then I used the screw driver on the left site to encourage the switch past the detents on the left and very quickly the switch was out of the mount. The wires from the refrigerator pulled out with the old switch. I unplugged the old switch from the wires and plugged in the new switch and shoved the new switch back into the mount, wiggled it a couple of times to make sure it was secure and the job was done. Once I applied the vise gripes at first, the whole job took less than a minute.
