The temperature sensor detects the temperature within the oven cavity. If your oven is too hot, not heating evenly, or has little to no heat when baking, you may need to replace the temperature sensor...
If your oven isn’t getting hot enough when you broil, this replacement broil element could be the fix. It’s the part that heats from the top of the oven to give food that crispy finish. Easy to instal...
Having trouble with your wobbly GE range? Our adjustable leveling leg is the simple solution you've been looking for. When your range isn't sitting perfectly even, it can lead to a host of issues from...
Replace cracked or damaged oven door glass with this genuine inner glass liner in sleek black. Designed to fit inside the oven door, it provides added protection, improves heat retention, and restores...
This bake element assembly provides the primary heat source for baking, delivering even and consistent temperatures throughout the oven cavity. It is replaced when the oven fails to heat properly or bakes unevenly.
$130.03
In Stock
Order within the next 3 hrs and your part ships today!
Removed six 1/4" hex nuts on rear of oven. Then through front/inside removed a single 1/4" hex nut to actually remove sensor. Unplug sensor connector, remove. Reversed steps, push oven back in place and plugged in. Tested oven function.
Unplugged appliance and removed 5 screws on back of stove/oven and removed plate. Disconnected the sensor and unscrewed it on the inside of the oven. Pulled the cord through and replaced with new sensor. Replaced all parts and plugged in the appliance and tested. Worked great.
1) pull out the stove 2) remove the 7 sheet metal screws holding the back panel on. (the panel that also covers where the cord splits and connects to the oven. 3) Find the small plastic connector located in the middle of the back of the range and unplug it. 4) open the front of the oven and remove the one screw holding in the oven temp sensor. 5) replace the sensor and make sure to "feed" the new cord through as best you can. 6) I had to dig through the insulation a little bit to find the new wiring harness 7) connect the wiring harness and put the back of the range back on
note: this was very simple to do if you think this might be the problem don't hesitate to handle this one yourself.
