This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch...
$26.58
In Stock
Order within the next 9 hrs and your part ships today!
First removed the end cover and clip on the end of the rack slide. Used a flat head screwdriver to push in the clip and carefully pried it out. Then using the same screwdriver, pried up on the rack roller clip attached to the dish rack. Once clip was free of the rack, slid the rack roller off through the front of the slider. Slid the new rack roller into the slider and snapped the roller clip onto the dish rack in the same place the old one was. Carefully twisted the plastic end cover and clip back onto the rack slider. Job complete. The trickest part of the job is removing the rack slider end cover.
Removed the end cap from the rack guide.Removed broken roller and stud.Slid on new rollers and studs attached to dishrack reinstalled end caps.Total time less then 15 minutes.Easy job.
I first removed the rail end caps by bending open the rail ends. They easily come off. The wheels slide out of the rack and the part snapped on to the rack removed. I used a screw driver to pry them off. New wheels are slid into the rail and snapped to the rack. End caps put back into place and rail tips bent back. Very easy.
