This is the replacement propane orifice for your gas range. You will find the orifice under the cooktop, beneath the burner. This part supplies liquid propane from the gas line to the stove top. Be su...
This oven rack provides stable support for cookware during baking or roasting. Its heat-resistant construction supports everyday cooking tasks. Replacing a bent or missing rack restores usable oven space.
When your GE gas range stops working, we've got you covered. Meet your ideal fix, the GE Power Line Cord. This isn't just any cord; it's specially designed for your GE gas range, promising a strong an...
If your oven isn’t heating up like it used to, this glowbar igniter might be the fix you need. It heats up to light the gas in your oven, helping it cook evenly and reliably. This replacement part usu...
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Paul
September 12, 2022
Igniters clicking when knobs are turned off. Have cleaned around the igniters but still every 5-7 minutes the igniter will spark (sometimes left side sometimes right side).
For model number MGAS724EL4WW
Hello Paul, thank you for your question. We have researched your model and found that the issue is probably with the Spark Module, part number PS235158. If that does not take care of the issue, then the problem is most likely to be related to the Igniter, part number PS1154879. If you require assistance to place an order, please contact customer service. We hope that helps!
Check the switch with an ohm meter, 0 resistance in the closed position = a bad switch. I went to the web site found the part. ordered it next day it shows up. Removed the pot grids and all control knobs for the burners and oven lifted the top of the stove up, and off. I removed face plate behind the control knobs 3 screws, I removed the 2 screws holding the oven switch. opened the oven and un cliped the thermostat wire from the back wall. Uncoiled new wire feed under the burner shield to the back of the unit and back down the old hole cliped in the new wire. put the 2 screws into the new switch and re-assembled the rest in the reverse order i took it off . all this while watching my 11 month old grandaughter.
Checked switch using test meter and found voltage going in but no voltage out when switch was turned on. Removed all burner knobs, raised top cover and disconnected two wires from thermostat switch. Removed the thermostat probe from oven interior by pushing it through hole in top. Removed two screws holding switch and pulled out entire assembly. Used a wire coat hanger pushed through hole for probe so I could see where to fish the probe into the oven. Hooked up electrical connections and tested. Everything worked well. Received part from Partselect in one business day. Excellent service and response.
The repair was fairly easy, you take off all the burner knobs there are small screws on the face of the cover panel and a few on the bottom That come off the cover panel should come off after you remove the screws and the switch for the oven light the wires just clip on the switch there are two .the thermostat is held on by two small screws that are on the cover panel.you lift up the burner panel you have room to feed the thermostat wire in the stove,there is a small hole in the back were you feed the wire through then the metal part is held in place by two small clips that are in the oven on the back wall.I didnt have to trouble shoot becase I knew what part I needed because it was broken,It was a fairly easy repair hopefully this is helpful
