MDT24P5AST Midea Dishwasher - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Steam was escaping the front, condensing on the door, and dripping down on the floor.
-
austin from saint marys, GA
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Washer fills then dumps before doing any washing with blue light on front panel and "Rinse" light flashing
turned off Circuit-Breaker to Dishwasher. Removed elec and water inlet and unit from under counter. On table with protection from scratching front, removed bottom panel of washer unit. Removed clamps to short hoses to inlet and output from pump assembly and removed ground and power connector. Replaced "one-time use" clamps with hose clamps and connected electrical. 20 ~ish minutes. re-installed washer unit under counter and re-connected elec and water input. Turned on Circuit-Breaker. Did not do anything different. Apparently, had low water pressure and when attempted to start at a time when it was obvious the water pressure was better (usually in the evenings/night) washer has worked again flawlessly 4 time now.
Parts Used:
-
Jim from Virginia Beach, VA
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!