M250 - Instructions

I think we had used a rubber band for some years when the belt melted ( I think the motor stalled and heated the belt) The new belt works fine. The Microwave cooks more uniformly with the belt working,

I didn't. Don't know how to get to light bulb to change it for this specific model

I removed the rear wheels, then I removed the blade, then the motor, then the front wheel assembly. The bolts holding the front wheel assembly were rusted and rounded trying to remove them, so I cut them out with a grinder. Afterwards I removed the remainder of the screw with a pair of pliers. I also removed the Water jet cleanout nozzle, found it was cracked, ordered the part from PartSelect, along with the screws needed to attach the front wheel assembly. I cleaned the remaining parts and re installed them onto the new deck. First, I installed the front wheel assembly, then the motor, then sat the mower upright, installed the blade, then took the rear wheel assembly and aligned it and fastened it to the deck. Last piece was the water nozzle. I placed it in the recess for it, and fastened it with the bolt. Then I tested the mower, and it worked without issue. Afterwards I used the new clean out port to rinse the underside of the deck, and it worked well.

Removed the ice brucket,
Removed the light shield by releasing one screw using a nutdriver.
Replacing the bulb and reinstalled the light shield.

Your web site is one of the best and most helpfull service sites I ever used. Just wish that in the future you will ship parts overseas.

The hardest part was taking out original light bulb because screws on shield where hard to unscrew after all this years . The old bulb vent out leaving neck in socket. It took narrow electrical pliers to get neck out .The generic appliance bulb did not fit and had aluminum neck ,not recommended for brass sockets in ovens.Putting new light bulb in was not the problem.

very easy

Screwed in light bulb and glass protector

My husband took the plastic cover off and took out old bulb and screwed in the new one. Then put the cover back on.

1. Unscrewed glass cover on bulb
2. Removed old bulb
3. Screwed in new bulb
4. Replaced glass cover
5. Mixed drink & baked cupcakes

I pulled down the wire around the glass cover. . . Released on end of the wire from its holder being careful to not let the glass cover drop. Unscrewed the bulb and replaced with replacement. Easy, easy.

Placed on stands to hold mower up, then removed wheels and clips, then placed new axle in place and replaced clips and wheels.

Can't do the repair. You sent me the two wing knobs I ordered, but no nuts. No one sells the nuts. I've driven all over trying to find them. Wasted my money and a lot of time. Zip ties are holding the handle on. I sent an email to customer service asking for the nuts, never heard a word from anyone. Another great example of how not to run a business.

Received the part the day after ordering. Appreciated the quick service and repair took less than a minute.