This temperature sensor, also referred to as a thermistor, is a genuine replacement component compatible with various appliance models. It works in coordination with the control board to monitor inter...
$103.87
In Stock
Order within the next 11 hrs and your part ships today!
Is your oven struggling to reach the right temperature for your baking needs? The problem could lie with the Heater Sheath, a critical component located at the base of your oven. Responsible for gener...
$202.96
In Stock
Order within the next 11 hrs and your part ships today!
Facing issues with your LG Electric Range Convection Oven? It might be due to a faulty fan motor. Luckily, we've got the solution in the shape of this authentic LG AC Fan Motor. This little gem ensure...
$164.95
In Stock
Order within the next 11 hrs and your part ships today!
Questions And Answers for LRE30451ST
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Verified P/N with LG. Took a few days . They sent names of several suppliers, cost was almost double. Ordered part from P/S, here in 2 days. Watched video on you tube. Unplugged, took off back, unplugged bake element, removed power box. The opening for bake element is still attached to rear panel by tiny bits of sheet metal. Used Dremel with cut-off wheel to cut thru nibs & deburr opening. this panel has to be removed, it rests on bottom panel & is held in position by power box. Removed bake element carefully, front of element broken, tried to put new element in, would not fit. Had to grind notches in bottom panel down to clear supports on new element. This did the trick. back together quick & no problems. If had to do again estimate less than 1 hour.. By the way am 81 yrs. young.
I searched online and found someone that seemed to have the exact problem. That person had replaced the lower burner and the same PCB board I replaced. I was able to test the lower burner without removing it and it tested OK. The PCB board in the article I had checked was burned and obviously bad but mine was not. I took a chance and ordered just the PCB board. I replaced this board and the oven now works perfectly. I seems this board was not turning on the bottom burner but the system thought it was working fine.
Very easy.1: Shut power to stove. 2: Remove 3 hex screws from oven to range top at underside of top. 3: Raise to from front and disconnect multi- connector at right rear of top. 4: flip over top and demoed 4 screws on hold down strap at each side. 5: Remove element from under strap. 6: Disconnect element from wires./ remember where wires were connected. Connect multi connected from stove. 7: Replace strap and flip top, screw it back on, put power back on. Only about 30 minutes even if you get a coffe break. Don’t even have to move stove.
