JVB67A2BB General Electric Range Hood - Overview
Sections of the JVB67A2BB
[Viewing 2 of 2]
Keep searches simple, eg. "belt" or "pump".
Single Roller
PartSelect #: PS257711
Manufacturer #: WC2X5144
Sold individually.
No Longer Available
Air Filter
PartSelect #: PS223619
Manufacturer #: WB02X10310
Keep your kitchen breathing clean and fresh with this GE grease filter, an essential puzzle piece in your range hood's top-notch performance. This behind-the-scenes hero catches and traps the grease f...
$56.47
Special Order
Questions And Answers for JVB67A2BB
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the JVB67A2BB
[Viewing 1 of 1]
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Controller board fried
Disconnected power and removed electrical cover
Disconnected wires from old controller one a time and connected to new controller as to not mismatch wire connections. Left new controller hanging off wires.
Raised vent and held using wood blocks to expose gap to use 1/4 inch wrench to undo screws from the inside (poor design for replacing the controller - this was the bulk of my time.) if this didn't work, I would have had to disassemble more of the downdraft.
Installed new controller.
Removed chocks, enabled power and tested...after verified, re-installed electrical cover.
Disconnected wires from old controller one a time and connected to new controller as to not mismatch wire connections. Left new controller hanging off wires.
Raised vent and held using wood blocks to expose gap to use 1/4 inch wrench to undo screws from the inside (poor design for replacing the controller - this was the bulk of my time.) if this didn't work, I would have had to disassemble more of the downdraft.
Installed new controller.
Removed chocks, enabled power and tested...after verified, re-installed electrical cover.
Parts Used:
-
Anthony from Stevensville, MD
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Wrench set
6 of 8 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!