This surface element is designed to deliver consistent heat to a designated cooking zone on the top of an electric range. Located beneath the cooktop surface, it plays a key role in maintaining accura...
This electric range surface element is designed to deliver consistent heat to a designated cooking zone, making it ideal for everyday meal preparation. Located beneath the cooktop, it plays a key role...
Need to know when your stove is hot and when it's not? Enter the GE Indicator Light - your best friend in kitchen safety. This small but vital piece makes it easy to spot when a burner is on or a cook...
If your cooktop isn’t heating like it used to, this 12-inch radiant element could be just what you need. It helps restore fast, even heating so you can get back to cooking with confidence. Designed to...
I turned off the circuit breaker and tested the cook top. I pulled the cook top out and laid a piece of plywood over the opening to work on the cook top and not scratch the granite counter top. The mistake I made was to turn the cook top upside down and separate the top from the housing. The dampening springs came off the burners and I could have damaged the elements (but they checked out ok). I turned the whole assembly right side up again and replaced the switch and put it all back together. It works great...thank you for the part.
Turned off power to counter top range and pulled-up from counter. Set range on counter and removed 16 screws from around the housing allowing me to pull-up and remove range top. Used socket to remove 4 screws holding control switch bracket in place and 2 screws holding bad switch in place. Disconnect wires from bad switch and reconnected to new switch. Placed and screwed switch bracket back in place. Before placing range top back I turned power back on to to test burner operation. Burner and switch operated correctly and I completed screwing range top back in place, setting back down into counter top. Done
Shut off circuit breaker. Removed cooktop from island counter. Removed all knobs. Removed all screws after finding layout diagrams of unit on your web site. Lifted glass top from metal cabinet. Ordered control after trouble shooting the problem. (Master Electrician). Obviously burned out from water in control. Ordered control on line and installed it when it arrived three days later. Before installing control I cleaned and dried out the area. I cleaned the glass top around all the control shaft holes and the rubber boots and lubricated them with silicone to help keep them dry and for ease of turning controls. Turned on circuit breaker and checked all burners, pilot light and hot top indicating lights.
