If your oven isn’t heating right or the temperature keeps changing, this sensor could be the problem. It helps your oven stay at the right temperature by sending signals to the control board. When it’...
Need better lighting inside your oven? This halogen bulb gives off a warm, clear light so you can easily check on your food while it cooks. It’s made to handle high heat and fits into the top of the o...
This part is a replacement screw for your oven. It is made of black metal and is sold individually. This screw is approximately 1/4 inch in diameter and about 1/2 inch in length. It is designed to con...
Maintain safe and consistent oven performance with this genuine cooling fan sensor board. This electronic component monitors the cooling fan’s speed and communicates with the main control board to pre...
This genuine OEM cooling fan assembly is designed for select wall ovens, ranges, and microwave/oven combinations to maintain proper airflow and prevent overheating during cooking. By circulating air a...
Got a GE appliance that's acting up? The solution could be simpler than you think! Let's get straight down to the nitty-gritty - you might just need the High Limit Switch. This small but powerful pa...
No Longer Available
Questions And Answers for JK3000DF3BB
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
The first step was to determine whether the problem was with the fan itself or the switch. I did this by opening the back cover and using a Volt meter to verify that the fan was not getting power. (I could have skipped this step.)
Next, I unplugged the range, closed up the back cover and lifted the range hood by removing two hex head screws that are just inside and on either side of the top of the opening in the range door. Propping the hood open, I removed the connector leading to the switch, then pushed the switch out the front. Inspection showed that the switch was damaged so I closed up the range and ordered the part from Part Select. Once the part arrived, it was a 15 minute job to unplug the range, lift the top, install the new switch, and close up the unit.
Caution. On starting to install the switch, I failed to unplug the range and my finger brushed one of the hot contacts leading to the switch. Thankfully, I was not injured. Do not repeat my mistake on this issue. Unplug the range even if you're only installing this simple switch.
After opening the Oven door, I removed the glass cover to view and locate the bulb, at the inside, top front of the Oven. Removed the burnt out bulb by pulling it in a forward motion towards the front of the Oven, slid the new bulb into place and the Oven is again functional.
