If your oven isn’t heating right or the temperature keeps changing, this sensor could be the problem. It helps your oven stay at the right temperature by sending signals to the control board. When it’...
Need better lighting inside your oven? This halogen bulb gives off a warm, clear light so you can easily check on your food while it cooks. It’s made to handle high heat and fits into the top of the o...
This range and oven cooling fan is designed to circulate air within the control compartment, preventing heat buildup and protecting sensitive electronics during and after cooking. By maintaining prope...
This part is a replacement screw for your oven. It is made of black metal and is sold individually. This screw is approximately 1/4 inch in diameter and about 1/2 inch in length. It is designed to con...
Maintain safe and consistent oven performance with this genuine cooling fan sensor board. This electronic component monitors the cooling fan’s speed and communicates with the main control board to pre...
Got a GE appliance that's acting up? The solution could be simpler than you think! Let's get straight down to the nitty-gritty - you might just need the High Limit Switch. This small but powerful pa...
This sturdy oven rack provides a reliable, elevated surface for baking and cooking, helping you maximize space inside your oven. Designed for a precise fit, it ensures stability and efficiency when pr...
After opening the Oven door, I removed the glass cover to view and locate the bulb, at the inside, top front of the Oven. Removed the burnt out bulb by pulling it in a forward motion towards the front of the Oven, slid the new bulb into place and the Oven is again functional.
This item was listed as fitting my GE wall oven. On arrival it appeared to be the exact part I needed. However upon my attempt to install it I found that the attached male electrical connector was very slightly different from the original part and it would not fit the female connector. At first I thought perhaps I could make a slight modification to the male connector but soon realized that the changes needed were too difficult to make. I tried to locate a matching female connector but no luck. Therefore I decided to use a terminal disconnect tool to unlock the wires from the connector and then I re-used my old connector. It worked! My wall oven is now operational again and my wife is very happy! P.S., I have been very happy with Parts Select for the availability of old parts and their superb instructional videos. They have helped me make several appliance repairs and are now my first choice
