This grease filter is almost fourteen inches long and almost twelve inches wide. This filter is intended for use with some downdraft cooktops and ranges.
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch...
This is the replacement brass seal for your range or cooktop. It is made of brass and is approximately 1 inch in diameter. This part may also be known as the surface burner orifice holder seal. It pre...
This exhaust vent blower wheel is almost seven inches in diameter, and just under four inches deep. It is made entirely of metal and is used with a range's venting system.
This may look different than the original, but is a functional equivalent. When installing this part, you may be required to drill holes and file the metal edges to adapt the switch to the original panel.
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Debbie
August 4, 2021
Whole assembly cooktop with 2 burners, used to be able to get all complete. Would be able to just drop in and go.
For model number JGD8130ADB20
Hi Debbie,
Thank you for your question. There is a complete cartridge that you may purchase for your stove.
The part number listed under your model number for the cartridge is PS2162200. If you would like to place an order for it, you may order it either online or by calling our customer service line and anyone will be happy to assist you. We hope this helps! If you have any questions, please let us know.
My customer has this cooktop in propane right now. We are converting her house to natural gas.
Do you guys sell a conversion kit for this appliance
Going from propane to natural gas
For model number JGD8130ADB20
Hi Paul, thank you for reaching out. To convert back to natural gas, you may need to remove the LP conversion kit first. Your model does not come with a natural gas kit, you may need the natural gas orifices. They come with the surface burner orifice holders. The left front surface burner orifice holder for your model is part number PS3406606, and the right front orifice holder is part number PS3406607. The left rear surface burner orifice holder is part number PS3406608, and the right rear surface burner orifice holder is part number PS3406609. We hope that helps!
Lift out sealed burner assembly rear of stove first while careully sliding to rear to disengage ignitor probes.Remove philips head screws from bottom sheet metal housing to expose bottom of burners Remove gas tube assembly screws and move tube away carefully.Unplug wires from ignitor.Remove screws for ignitor .Remove ignitor, I noticed that rust and dirt had built up around burner to pan connection.I used my oil filter wrench to turn slightly the burner to remove it from the pan to clean.Reassembled in reverse order.