This twenty-five watt microwave light bulb is two and a half inches long. It has a small, screw-in base and it carries 120V. This item sells in a quantity of one, though many microwaves require two.
If your refrigerator or freezer is too warm, or making noises, you may need to replace the fan blade. The fan blade attaches to the evaporator motor, which is in the freezer section, to help circulate...
This fan motor circulates the air through the refrigerator grille and cools the compressor and condenser coils. It also helps to evaporate extra water in the drain pan. Please note: If the original fa...
$246.97
In Stock
Questions And Answers for JF42NXFXDW00
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
SHANTI
July 25, 2023
WHEN I FLIP THE SWITCH ON FROM THE TOP UNIT (COMPRESSOR UNIT), I CAN SEE THAT THE FRIDGE IS ATTEMPTING TO START BUT IT DOES NOT REALLY START. THE DISPLAY WHERE IT SHOWS THE DIGITS OF THE TEMP IS REMAINS BLANK. I DISCONNECTED THE INVERTER GOING TO THE COMPRESSOR, AND EVEN THEN THE DIGITS DON'T DISPLAY THE TEMP. AS IF THERE IS NO POWER. WHAT WOULD YOU THINK IS THE FAULT?
For model number JF42NXFXDW00
Hello Shanti, thank you for the question. We have concluded that the issue is with the electronic control board. We suggest you replace the electronic control board, part number PS11753653, to fix the issue. We hope this solves your problem!
First I shut the water off to the refrigerator.then i pushed the big button in the middle of the grille below the refrigerator door. pulled out the old filter, took the front cap off the old filter put it on the new filter. took the two red caps off the new filter. pushed the filter in till it locked in place. all done! Turned the back on.
It's simple enough in theory: read the side of the box and follow the instructions. BUT you need to really push the knob in pretty hard (I am a girl, and my hand strength isn't that good). If you don't, when you turn the knob, the filter won't come out, then it's tougher. So: make sure the knob pops before you turn!