JCK5000SF2SS General Electric - Overview
Models starting with JCK5000SF2SS
Click on the best match to narrow your results.
Keep searches simple, eg. "belt" or "pump".
SENSOR Assembly
PartSelect #: PS8754411
Manufacturer #: WB21X10165
If your oven isn’t heating right or the temperature keeps changing, this sensor could be the problem. It helps your oven stay at the right temperature by sending signals to the control board. When it’...
$64.26
Special Order
Range Lamp Halogen Bulb G9
PartSelect #: PS8754479
Manufacturer #: WB25T10102
Need better lighting inside your oven? This halogen bulb gives off a warm, clear light so you can easily check on your food while it cooks. It’s made to handle high heat and fits into the top of the o...
$26.78
Special Order
COOLING FAN
PartSelect #: PS8754491
Manufacturer #: WB26T10066
This range and oven cooling fan is designed to circulate air within the control compartment, preventing heat buildup and protecting sensitive electronics during and after cooking. By maintaining prope...
$171.37
Special Order
Range Screw
PartSelect #: PS222157
Manufacturer #: WB01T10008
This part is a replacement screw for your oven. It is made of black metal and is sold individually. This screw is approximately 1/4 inch in diameter and about 1/2 inch in length. It is designed to con...
$13.95
Special Order
Fan Sensor Board
PartSelect #: PS8754576
Manufacturer #: WB27T11463
Maintain safe and consistent oven performance with this genuine cooling fan sensor board. This electronic component monitors the cooling fan’s speed and communicates with the main control board to pre...
$77.56
Special Order
Screw
PartSelect #: PS271689
Manufacturer #: WH2X930
This screw is sold individually.
$13.95
Special Order
GLASS OVEN WINDOW
PartSelect #: PS8755449
Manufacturer #: WB56T10350
This glass oven window allows users to monitor cooking progress while maintaining proper heat containment. Heat-resistant construction supports safety and durability. Replacing cracked glass restores ...
$100.92
Special Order
Wall Oven Door Lock Assembly
PartSelect #: PS10065136
Manufacturer #: WB10X23814
The door lock assembly locks the oven door during the self-cleaning cycle.
$138.14
Special Order
HIGH LIMIT SWITCH
PartSelect #: PS17626188
Manufacturer #: WB24X46906
Got a GE appliance that's acting up? The solution could be simpler than you think! Let's get straight down to the nitty-gritty - you might just need the High Limit Switch. This small but powerful pa...
No Longer Available
Common Symptoms of models starting with JCK5000SF2SS
[Viewing 3 of 3]Oven is too hot
Fixed by
these parts
these parts
Show All
Will Not Start
Fixed by
these parts
these parts
Show All
Oven not heating evenly
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
A burnt out bulb
After opening the Oven door, I removed the glass cover to view and locate the bulb, at the inside, top front of the Oven. Removed the burnt out bulb by pulling it in a forward motion towards the front of the Oven, slid the new bulb into place and the Oven is again functional.
Parts Used:
-
George from PALM COAST, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
11 of 19 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The oven would not hold an even temperature.
I used a Trox bit to remove one screw, replaced the oven sensor and reinstalled the screw. The whole project took less than 5 minutes.
Parts Used:
-
Jack from Bremerton, WA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
7 of 7 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
oven light falied
This item was listed as fitting my GE wall oven. On arrival it appeared to be the exact part I needed. However upon my attempt to install it I found that the attached male electrical connector was very slightly different from the original part and it would not fit the female connector. At first I thought perhaps I could make a slight modification to the male connector but soon realized that the changes needed were too difficult to make. I tried to locate a matching female connector but no luck. Therefore I decided to use a terminal disconnect tool to unlock the wires from the connector and then I re-used my old connector. It worked! My wall oven is now operational again and my wife is very happy!
P.S., I have been very happy with Parts Select for the availability of old parts and their superb instructional videos. They have helped me make several appliance repairs and are now my first choice
P.S., I have been very happy with Parts Select for the availability of old parts and their superb instructional videos. They have helped me make several appliance repairs and are now my first choice
Parts Used:
-
Paul from RICHMOND, TX
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
5 of 7 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!