If your oven isn’t heating properly or your food isn’t baking evenly, this bottom heating element might be the issue. It provides steady heat for baking and roasting and fits select Bosch, Thermador, ...
This wire oven rack provides a stable, flat surface for baking, roasting, and cooking, ensuring even heat distribution throughout the process. Designed for durability and a precise fit, it helps organ...
If your warming drawer isn’t sliding open like it used to, this push-to-open slide kit might be just what you need. It lets you open the drawer with a simple push—no handle required—making it super co...
Need a new display module for your Bosch, Thermador, or Gaggenau appliances? You're in the right place! We have the authentic Bosch Display Module that's built specifically for these brands. This impo...
This meat probe is designed to help achieve precise cooking results by accurately monitoring the internal temperature of food while it cooks in the oven. The metal probe is inserted directly into meat...
This outer oven door panel serves as the exterior heat shield and protective surface for your Bosch wall oven or range, helping maintain heat efficiency while providing a sleek, durable finish. Often ...
When your Bosch, Thermador, or Gaggenau appliance starts to lose its heat, it can be a real headache. But don't worry, that's where this authentic Bosch Heating Element comes in! It's not just a spare...
Make cooking easier with this telescopic oven rack for Bosch wall ovens. It slides out fully so you can check or remove dishes without reaching into a hot oven. The smooth ball-bearing design handles ...
$669.83
In Stock
Questions And Answers for HIIP056U/03
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Removed the wall oven to access temp probe connector strapped to the back of the oven. removed 2 screws holding probe inside the oven & replaced. Searched for the "fixing kit" thermostat part I was suggested to replace along with the probe. No thermostat type part was found in my oven, even though Bosch says it fits "somewhere". Reinstalled the wall oven & tested. The temperature is working normal now. Will return the fixing kit.
First, cut the power and remove the oven from the cabinet.
The bake element is accessible from the back and sits in a drawer.
As someone else said, you have to use pliers to bend the cover of the drawer, you will make some damage to the cover, but there is nothing you can do about it.
Make a note of what wire goes to the right and to the left so you can plug them back like it was before.
When you replace the bake element, make sure you insert it in the straps so it won't wiggle when it heats.
To close the cover that you bent, you will need a helper and push really hard.
Watch the YouTube video. Turn off power or unplug the range. Remove 5 gas control knobs. Remove four T20 screws on Control panel. one on each end, L and R, two underneath, L and R. Pull off control panel and carefully flip it up onto the range, being careful not to stretch the wiring harness. Carefully remove two wiring connectors (pinch and pull method) Remove four T20 screws securing the Control panel mount then turn it over 180 degrees. Straighten the mounting tabs until the control panel easily slides off of its mount. Remove and replace the control panel and sheet. Reverse the procedure to reinstall. It took me longer to clean the components and the area that to repair the problem. Tip: Isopropyl alcohol in a spray bottle and a cloth cuts the grease and grime, if needed, with very little effort and no scratching.
