If your oven isn’t heating properly or your food isn’t baking evenly, this bottom heating element might be the issue. It provides steady heat for baking and roasting and fits select Bosch, Thermador, ...
This wire oven rack provides a stable, flat surface for baking, roasting, and cooking, ensuring even heat distribution throughout the process. Designed for durability and a precise fit, it helps organ...
This genuine temperature sensor ensures precise heat regulation inside your oven for consistent cooking results and improved safety. Designed to measure the oven cavity temperature, it communicates wi...
This genuine OEM energy regulator, also known as a surface element control switch, is designed for ranges and ovens to manage heat output and maintain consistent cooking temperatures. It controls the ...
If your warming drawer isn’t sliding open like it used to, this push-to-open slide kit might be just what you need. It lets you open the drawer with a simple push—no handle required—making it super co...
Need a new display module for your Bosch, Thermador, or Gaggenau appliances? You're in the right place! We have the authentic Bosch Display Module that's built specifically for these brands. This impo...
This genuine OEM energy regulator helps control the heat output of an electric surface burner by regulating power levels from low to high. Replacing a faulty switch can restore proper temperature cont...
Give your range a fresh look and reliable performance with this black glass cooktop. It’s made for 5 burners and offers a smooth surface that’s easy to clean and built to last. Just unplug your applia...
First, cut the power and remove the oven from the cabinet.
The bake element is accessible from the back and sits in a drawer.
As someone else said, you have to use pliers to bend the cover of the drawer, you will make some damage to the cover, but there is nothing you can do about it.
Make a note of what wire goes to the right and to the left so you can plug them back like it was before.
When you replace the bake element, make sure you insert it in the straps so it won't wiggle when it heats.
To close the cover that you bent, you will need a helper and push really hard.
Watch the YouTube video. Turn off power or unplug the range. Remove 5 gas control knobs. Remove four T20 screws on Control panel. one on each end, L and R, two underneath, L and R. Pull off control panel and carefully flip it up onto the range, being careful not to stretch the wiring harness. Carefully remove two wiring connectors (pinch and pull method) Remove four T20 screws securing the Control panel mount then turn it over 180 degrees. Straighten the mounting tabs until the control panel easily slides off of its mount. Remove and replace the control panel and sheet. Reverse the procedure to reinstall. It took me longer to clean the components and the area that to repair the problem. Tip: Isopropyl alcohol in a spray bottle and a cloth cuts the grease and grime, if needed, with very little effort and no scratching.
