HDA3400F00WW Hotpoint Dishwasher - Overview
Sections of the HDA3400F00WW
[Viewing 3 of 3]
Keep searches simple, eg. "belt" or "pump".
Door Gasket - White
PartSelect #: PS958908
Manufacturer #: WD08X10057
This one piece dishwasher door gasket provides a water tight seal to keep water from leaking out of your dishwasher.
$104.33
Special Order
Piston and Nut Assembly
PartSelect #: PS260690
Manufacturer #: WD24X10018
This is used for the check valve.
$30.95
Special Order
Gasket Insert
PartSelect #: PS258653
Manufacturer #: WD08X10015
The gasket insert is connected to the gasket in the bottom of your dishwasher door. It is a small piece of white plastic that measures approximately 4 inches by 1 inch, and is sold individually. The g...
No Longer Available
Hinge Arm Link
PartSelect #: PS259336
Manufacturer #: WD14X10009
The hinge link on your dishwasher connects the spring to the dishwasher door hinge. If the hinge link becomes cracked or damaged, you may not be able to shut or lock your dishwasher door properly. In ...
$17.70
Special Order
Rinse Aid Fill Cap
PartSelect #: PS2351824
Manufacturer #: WD12X10284
This part helps keep the rinse aid the dispenser until its needed.
$78.79
Special Order
Water Inlet Valve
PartSelect #: PS259368
Manufacturer #: WD15X10003
This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of wat...
$111.45
Special Order
Drain Solenoid and Bracket Assembly
PartSelect #: PS1481923
Manufacturer #: WD21X10268
This valve opens in order for the water to drain out of the dishwasher.
$79.98
Special Order
Drain Solenoid Kit
PartSelect #: PS260117
Manufacturer #: WD21X10060
This kit includes the armature and linkage assembly.
$110.06
Special Order
Impeller and Seal Kit
PartSelect #: PS259598
Manufacturer #: WD19X10032
This part helps stop your dishwasher from leaking. This kit includes the impeller, seal, blade, filter, skidder and skidder holder.
No Longer Available
Motor and Pump Kit
PartSelect #: PS260801
Manufacturer #: WD26X10013
This pump and motor kit replaces many old style pump and motor kits that were manufactured since 1970. The instructions are included with this kit to help you to make it adaptable to your dishwasher.
...
$275.11
Special Order
Door Latch Kit
PartSelect #: PS259293
Manufacturer #: WD13X10003
This door latch kit is used for dishwashers.
$62.07
Special Order
Leveling Leg
PartSelect #: PS261477
Manufacturer #: WD2X320
This leveling leg is located under the dishwasher cabinet. It is sold individually.
$19.99
Special Order
Questions And Answers for HDA3400F00WW
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the HDA3400F00WW
[Viewing 10 of 10]Leaking
Fixed by
these parts
these parts
Show All
Not draining
Fixed by
these parts
these parts
Show All
Not cleaning dishes properly
Fixed by
these parts
these parts
Show All
Will not fill with water
Fixed by
these parts
these parts
Show All
Door latch failure
Fixed by
these parts
these parts
Show All
Will not dispense detergent
Fixed by
these parts
these parts
Show All
Will Not Start
Fixed by
these parts
these parts
Show All
Door won’t close
Fixed by
these parts
these parts
Show All
Noisy
Fixed by
these parts
these parts
Show All
Not drying dishes properly
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Dishwasher wouldn't fully drain
I removed the four screws holding the screen and molded plastic cage inside the rear of the dishwasher to expose the check valve assembly. I then unscrewed the piston and nut assembly with my hand and replaced it with the new one. I found that the rubber cone shaped valve on the old piston and nut assembly was entirely disintegrated. This easy repair solved the problem.
Parts Used:
-
Dan from Minnetonka, MN
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver
191 of 206 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dish washer is not running through cycles
First and formost before you buy read everything in trouble shooting your dishwasher. Then you do not buy parts you do not need. First you turn off power, then water. Remove two screws, a rubber hose and a hard line by unscrewing if you are lucky some contractors might sweat this on. No biggie just two extra steps that's all. do in reverse to assemble...
Parts Used:
-
mike from huntley, IL
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers, Screw drivers, Wrench (Adjustable), Wrench set
93 of 107 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
D/W would not drain. Water standing in bottom.
It is a simple process to replace the drain solenoid on these dishwashers, having replaced several in the past few months.
After removing the front bottom panels, I removed the 2 screws holding the old solenoid, unplugged the wire harness, and then switched over the springs to the new solenoid. Assembly was installing 2 screws, and plugging in the wire harness.
I work on a 260 + unit property, as well as working for a property management company who rents single family homes.
PartSelect.com is an excellent source of parts, shipping in a quick manner, allowing the repairs to be completed in a timely manner. Thank you.
After removing the front bottom panels, I removed the 2 screws holding the old solenoid, unplugged the wire harness, and then switched over the springs to the new solenoid. Assembly was installing 2 screws, and plugging in the wire harness.
I work on a 260 + unit property, as well as working for a property management company who rents single family homes.
PartSelect.com is an excellent source of parts, shipping in a quick manner, allowing the repairs to be completed in a timely manner. Thank you.
Parts Used:
-
Ed from Cornelius, NC
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver, Screw drivers
65 of 71 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!