If your oven isn’t heating properly or your food isn’t baking evenly, this bottom heating element might be the issue. It provides steady heat for baking and roasting and fits select Bosch, Thermador, ...
This wire oven rack provides a stable, flat surface for baking, roasting, and cooking, ensuring even heat distribution throughout the process. Designed for durability and a precise fit, it helps organ...
This genuine temperature sensor ensures precise heat regulation inside your oven for consistent cooking results and improved safety. Designed to measure the oven cavity temperature, it communicates wi...
This outer oven door panel serves as the exterior heat shield and protective surface for your Bosch wall oven or range, helping maintain heat efficiency while providing a sleek, durable finish. Often ...
When your Bosch, Thermador, or Gaggenau appliance starts to lose its heat, it can be a real headache. But don't worry, that's where this authentic Bosch Heating Element comes in! It's not just a spare...
This oven control knob allows users to easily select and adjust cooking temperatures or modes. Designed for smooth rotation and a secure fit, it restores precise control and a finished appearance when...
This programmed control module and circuit board serves as the central control system for a wall oven, managing critical functions such as temperature regulation, cooking modes, heating elements, cool...
First, cut the power and remove the oven from the cabinet.
The bake element is accessible from the back and sits in a drawer.
As someone else said, you have to use pliers to bend the cover of the drawer, you will make some damage to the cover, but there is nothing you can do about it.
Make a note of what wire goes to the right and to the left so you can plug them back like it was before.
When you replace the bake element, make sure you insert it in the straps so it won't wiggle when it heats.
To close the cover that you bent, you will need a helper and push really hard.
Replace facia panel. Turn off power to the oven. Remove oven control knobs by inserting finger tips under each side of the knob and pulling. Open oven, remove mounting screws. slide the oven out a few inches to allow clearance for the removal of the facia panel. Remove 3 torx screws under the bottom of the facia panel. The wiring harnesses for the LED temperature display and touchscreen are very short and must be disconnected in order to remove the facia. Slowly pull out the bottom of the facia panel taking care not to damage the wiring harnesses. Locate the wiring harness connections and disconnect. Lift the facia panel up and away from the oven. Carefully remove the LED temperature display from the back of the facia panel touch screen. Installing the new facia panel: The LED temp display wiring harness is very short and difficult to connect with the LED display installed on the new facia touchscreen panel. For this reason connect the wiring harness to the LED temp display before installing it in the new facia. Once the wiring harness is connected to the LED display, place the facia panel in position and reach under, align the LED display with the touch screen panel mounts and snap into place. Connect the touchscreen harness, position the facia panel and replace the three screws. Secure the oven in place, replace the knobs, and turn on the power.
