This lid lock, also referred to as a door lock, is a genuine replacement component designed to secure the washing machine lid during operation. It ensures the appliance recognizes when the lid is prop...
This suspension rod and spring assembly is a manufacturer-approved replacement part designed to stabilize the washer tub during operation. Positioned on the left side of the machine, it is one of four...
This inlet valve is designed for use in compatible top-load washing machines and plays a key role in regulating water flow during the wash cycle. Controlled by electrical signals, the valve opens and ...
Are you struggling with a malfunctioning washing machine? We have just the solution you need'the GE Drain Hose. This simple but essential part is tailor-made for washing machines, tasked with safely d...
Having trouble with your GE washer? Our Nut Hub could be just the solution you need. This little device has a big job ? it tightly secures your washer hub to the gear case shaft. Its accuracy helps yo...
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Michael
December 5, 2019
The pulsator is not spinning during wash cycle, but the arm is not stripped! What could be wrong?
For model number GTW680BSJ2WS
Hello Michael, thank you for your question. We would recommend replacing the washer and bolt that holds the pulsator to the unit. Those part number are BELLEVILLE WASHER Part #: PS12343240 and NUT HUB Part #: PS8757009. I hope this helps!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Drain all the water out of the tub with a shop vac Remove rear drain hose and drained rest of water into a bucket Remove small rear panel (bottom left hand corner) where the drain hose connects Tipped washer up about 45 degrees to get underneath it - Supported it with a few paint cans Remove internal drain hose/clamps from pump - w/ pliers Remove belt cover (gray plastic) with socket - 3 bolts Remove wire assembly plug from socket Remove old drain pump with socket - 3 bolts Install new drain pump - 3 bolts - plug wire assembly into socket Reinstall belt cover - 3 bolts Reinstall hose to drain pump (note panel will be inside washer) Feed drain hose panel through hole and reinstall - 1 nut Re attached drain hose to exterior drain plug You are done !
Very simple to repair. Be sure to drain the tub outside or into the sump pump then lay the washer on its side. The pump is right there on the bottom of the basket with 3 bolts. You will also need to remove the belt cover to get to the plug. So simple and saves you hundreds off repair man prices.
Removed the control panel back plate cover. Removed the 3 screws that held the water control valve in place. I then unplugged each solenoid one at a time and plugged it into the new control valve. Once all wires were transferred, I pulled the old valve up and put the new valve on. Then reinstalled the screws that held it down and reinstalled the cover plate. Very simple job !
