The relay switch may also be known as the door micro switch and is a part for your microwave. The function of this part is to monitor the door latch and communicate whether the door latch is open or c...
This roller guide sits underneath the glass turntable tray.
$129.31
Special Order
Questions And Answers for GLMV169DSC
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Matt
February 18, 2023
Microwave constantly running won't shut off
For model number GLMV169DSC
Hi Matt, thank you for drawing our attention to this question. Firstly, you should check the door switch, part number PS8769124, by using a multimeter. If the electrical path is present, then we recommend you replace the control board, part number PS2339507. We hope this will fix your issue.
Hi Gregory, thank you for your question! Based on our research, you may have a damaged diode, part number PS2343253. The diode converts AC input voltage into DC output voltage. We would recommend replacing the diode to fix the issue. We hope this solves your problem!
I first removed the top plate above the microwave door (3 screws), then I removed the plate containing the buttons and clock. The microwave has 3 relay switches and they are in a little holder. The holder was too difficult to remove so I just removed the bottom switch and replaced. The microwave started right up.
Removed the 3 screws to drop the lower panel and, removeed the turn table plate and ring. Then removed the 2 screws holding the motor, the 2 wires attached to the motor and removed the old motor.Replaced the new motor in the reverse order. DO NOT FORGET TO UNPLUG THE MICROWAVE FIRST.
was told buy a repair person to check the door micro switches as it was a common problem. removed the top plastic air grill to get access to the screw that holds in place the control cover. After unplugging the unit, i took out the (2) screws that held in the switches and removed them (3). One switch was a bit melted so i tested it with a 12 volt battery and it was bad. Ordered a new one from Part select and got it fast . Works great .