GCG1580P0SS General Electric Trash Compactor - Overview

1) pulled the compactor from under the counter and unplugged it. 2) tipped it on its side 3) removed 5 screws (3 on the motor side and two on the bottom) an took off the bottom cover plate. 3) using the pliers i pulled of the retainer clip from the large drive gear(it had broken on only the hub remain attached) 4) i then just slid in the new gear, snapped in the retainer clip and buttoned up the cover plate. Note I did not replace the other parts that came in the package because the existing ones seemed ok.

After calling a repair man and being told my appliance was to old for him to repair I discovered your website. I simply entered the model number and a picture of the part I was looking for was easily found. I ordered online and received the replacement parts 5 day's later. I simply swapped out the old locking nuts with the new ones from your website and the repair was complete. What could have been an easy $100 repair cost a fraction of that and the trash compactor is working just fine.

1)Pulled the unit out remove the top and bottom covers. 2)Disconnected the drive chain by removing the sproket from the motor. 3)Unscrewed the drive rod on the side that worked and removed the ram. 4)Reassembled and used the bin for trash while waiting for the part. 5)The nut came with clips included (this was not noted in the order but is vital) removed the stripped nut by breaking the old clips. 6)Installed the new nut, clips on the ram. 7)Installed the ram onto both drive screws. I had to hold the 'top sensor' switch up to reverse the screws to lower the ram. 8)Rinstalled the top and the appliance. 2 thru 4 dealing witht the chain, sproket and screw were fairly complicated operations.