This microwave waveguide cover, also known as a stirrer blade cover, is an essential component for maintaining optimal cooking performance. It protects internal parts from food splatter while allowing...
Cook your meals evenly with this sturdy glass turntable tray. It fits in the center of your microwave and rotates food for better results. Made from heat-resistant glass and easy to clean, this tray i...
$203.38
Special Order
Questions And Answers for FPMO227NUFA
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Amy
April 10, 2023
Makes a zapping sound as if there is metal in the microwave. I think it’s the little paper panel insert on the side that needs to be replaced. It has a burn on it as if it were zapped by lightning
For model number FPMO227NUFA
Hi Amy, thank you for reaching out. Based on our research, you may need to replace the waveguide cover, part number PS11766161. We hope this helps!
Hi Jose, thank you for reaching out. Based on our research, the glass tray, part number PS12705742, for your model measures approximately 16 1/2 inches in overall diameter. We hope this information helps!
First problem was there are a lot of different enclosures for NUFA models. After much research, I found a video of a smaller countertop micro that had the same screw pattern as my large Gallery over the stove unit. For my micro, you remove the screws on the back, one screw on the left side, and the entire cover lifts off. I then discharged the capacitor using a pair of insulated needle nosed pliers, and took a picture so I could replug everything correctly. Then removed all of the connectors and one screw holding the board in place, and removed the old board. After that, I just did everything in reverse, and plugged it in. Voila! I was finished. It was a very simple job once I found how to access the control board. Hope this helps, and my thanks for the prompt parts delivery. Don Crow
