Also known as Probe. The quick connect on this part may be different than your original part. If it doesn't fit, you have to cut off the quick connect and wire together with porcelain wire nuts.
$64.15
In Stock
Order within the next 12 hrs and your part ships today!
Order within the next 12 hrs and your part ships today!
Questions And Answers for FPCS3085LFA
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Griff
February 3, 2020
What does error code e0 95 mean? It shows up on the 2-digit leds on the burner controls. This happens right after plugging in the unit.
For model number FPCS3085LFA
Hello Griff, thank you for your question. That error means that the board sees an issue with the voltage to the unit. It may be an issue with your home's power supply or the appliance itself. You will need to test right at the receptacle where it is wired into the home's wiring. If that voltage is found to be okay (240 volts between red and black wires, 120 volts between black and white and red and white), the issue would be with one of the control boards. I hope this helps.
Was this helpful?
Thank you for voting!
DEBBY
February 26, 2023
OVEN WORKS FINE. CANT GET COOK TOP TO WORK. USED TO WORK IF WE TURNED OVEN ON FIRST. NOW BEEPS CONSTANTLY SO HAVE TO THROW BREAKER. GET ERROR CODES 32,52,92. THIS UNIT IS IN OUR VACATION HOME AND WAS VERY SELDOM USED.
For model number FPCS3085LFA
Hello Debby, thank you for reaching out. Errors 32, 52, and 92 indicate that the voltage on the service section is too low. To fix this issue, we would recommend checking the relay board, part number PS1992555, and the induction generator, part number PS1529368. We hope this helps, good luck with this repair!
Replaced clock control by removing surface burner control knobs and plastic nuts, and then the cover over the oven control. Two screw hold the clock in place, after removal and disconnecting the plug-in you can reinstall the new clock control. The Heat Sensor inside the oven will also need to be replaced. It is located inside the oven and attached with two screws; the back of the oven will need to be removed to unplug. Reverse removal procedure and turn the power back on to the stove.
PF alarm appeared on display. Noticed clicking when cord was moved. Had arced for some time and melted original block. New part slightly different. Only has 3 lugs, old one had six. Stack using washers provided. Take note of colors before disassembly. Use caution while working through access opening. The edges are sharp. Only tools needed are phillips screwdriver, deep socket for lug nuts. Nut driver optional. Hope this is helpful.
Repair was quite easy, as long as you have the instructions for removing the door. The screws that hold the bottom of the door to the fixed hinge are placed into the side of the hinge assembly after removal; this holds the door at a 45 degree angle for easy removal. After that, just place the door on a flat surface and dismantle the door from the inside. The inner glass is contained in a metal frame with another piece of glass; this frame comes apart easily using the clips in each side. The door assembles easily after the glass is replaced; just take your time and give yourself enough room to lay out the parts as you go. Good luck!