This grey OEM dishwasher tub gasket is a 73" grey rubber part that creates a seal around the dishwasher to prevent any water leakage during a cycle. If it's damaged or broken, you'll start seeing wate...
The single rack roller kit comes with one axle/clip and one wheel/roller. The rack wheel is designed to allow the rack of your dishwasher to roll in and out. If the rack will not complete this task, o...
This door seal is for dishwashers.
Door seal seals the gap between the opening to the dishwasher tub and the outer edge of the door.
After installing the door seal, shut the dishwasher door and ...
This plastic cover and stem assembly helps hold the lower spray arm in place.
$39.53
In Stock
Questions And Answers for FFID2426TS3A
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Marcella
August 27, 2022
Water will not go into dishwasher what part would I need
For model number FFID2426TS3A
Hello Marcella, thank you for asking! You need to confirm that the water inlet tubes and filters are not blocked or damaged. If they are fine, then this issue is mostly caused by a defective water inlet valve (part number: PS16218688) and/or a defective float switch (part number: PS3492842). It controls the flow of water to the washer and when defective it will not allow the flow of water to the washer. We hope this helps. Please feel free to contact our customer service for any further queries.
Dishwasher starts I can hear it filling then nothing will run through the cycles release soap etc open it up after and soap is dripping down the door and dishes still dirty. I had cleaned the float value and it worked once went to wash a 2nd load back to original issue
For model number FFID2426TS3A
Hello Daniel, thank you for your question. We suggest check the Lower Spray Arm Support PS9865072( item # 10) and the Lower Arm Support PS12712289 (item # 62). It is the pressure of the water that sprays from the arm that cleans the dishes. Thank you for your inquiry, good luck with this repair.
I removed old tub gasket, which the door presses against to make a seal, and put the new one in. Flat tip screwdriver was used to gently press gasket in.
I looked under and found that 2 brass nuts that secured the heater element through the base housing of the dishwasher has split down each side of the nut and no longer was tight enough to keep water from leaking around either end of the heater element. I powered down the dishwasher at the circuit breaker and then reached under the dishwasher and pulled away the 2 wires that were attached to each side of the heater element. I removed the two nuts and replaced them with the parts I ordered from partselect.com. I then put the appropriate wires back at the end of the heater element and ran the dishwasher to check for leaks. No leaks... it was fixed.