The Lower Spray Arm is used in your dishwasher to spray water and clean your dishes. If broken there will be visible damage or your dishes may no longer be cleaned properly. If your spray arm is broke...
This grey OEM dishwasher tub gasket is a 73" grey rubber part that creates a seal around the dishwasher to prevent any water leakage during a cycle. If it's damaged or broken, you'll start seeing wate...
The upper spray arm helps distribute water from the top of the dishwasher tub.This spray arm is a genuine OEM replacement part for your dishwasher. This spray arm is for the upper part of your dishwas...
The single rack roller kit comes with one axle/clip and one wheel/roller. The rack wheel is designed to allow the rack of your dishwasher to roll in and out. If the rack will not complete this task, o...
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Jonalyn
December 27, 2019
Dishwasher is not turning on, lights just continue flashing. Water is not draining completely. What is wrong with it?
For model number FFBD2408NS5B
Good Day Jonalyn. Thank you for your question in regards to your unit (Model Number FFBD2408NS5B). When the lights on a Frigidaire dishwasher are blinking, the first thing to do is perform a basic reset. To do this, simply unplug the dishwasher or flip off the circuit breaker and wait a few minutes before restoring power. Then restart the dishwasher and make a new wash selection. Hope this helps. Best Regards.
2 people found this helpful.
Was this helpful?
Thank you for voting!
Shahin
January 18, 2020
Washer, drying, cleaning lights keep flashing tried to reset by unplugging for 5 min. Plugged back in set washer to quick wash. It switched to normal wash and will not stop running. Please help!!
For model number FFBD2408NS5B
Hello and thank you for writing.
If water fails to enter your dishwasher or not enough water fills the tub, the "Clean" light will continue to flash until you fix the issue. Check the amount of water in the tub after you start the wash cycle. If the valve is open, replace the water inlet valve PS9865067 on the dishwasher. We hope this helps. Please contact us anytime if you require further assistance.
Repair was simple. I unscrewed the old grommet which held the old spray arm and screwed-on the new one. About 30 seconds was required. Other people having this problem should note that the spray-arm is made of three pieces which are inseparable when the arm is new. The arm is sold in this form. However, when your machine is having the problem that the arm falls off, the three pieces become separate. When you want to replace the spray arm, only one new part needs to be ordered because this part encompases all three components.
I have had to keep replacing the spray arm on the bottom of my dishwasher which takes like 2 seconds to do.. First you open the dishwasher and than pull the bottom basked forward and reach down and pull the spray arm up and pop the bottom of the spray arm off and put it on the new spray arm and slip it back into the dishwasher over the thing that makes it spin around.. but the tricky part is and I didn't know this and this is why my dishwasher spray arm kept falling over and melting on the heating element.. you have to turn it till it clicks in.. and your done..