Cook with confidence using this surface element switch for your electric range. It lets you adjust the heat on your large burner for perfect cooking results every time. Designed for an 8-inch element,...
$104.28
In Stock
Order within the next 1 hr and 21 mins and your part ships today!
Is your range not cooking as it used to? The 6-inch Frigidaire Surface Element is your solution. This genuine OEM part is specifically designed to restore heat to the cooking area on the top of your r...
$212.74
In Stock
Order within the next 1 hr and 21 mins and your part ships today!
Got a faulty burner coil? We've got your back! Here's a genuine Frigidaire Coil Surface Element to the rescue. This replacement part is explicitly designed for the cooking surface of your stove. At 8 ...
$230.66
In Stock
Order within the next 1 hr and 21 mins and your part ships today!
First I unplugged the stove.Removed the upper control panel back (10 phillips screws). Removed the plastic dial( pulls straight off). Removed the 2 screws behind the dial that is holding the switch in the control panel. Took one wire at a time off the old switch and put them on the new switch according to each electrical spade marking. L1, L2, H1, H2 and P. Installed the new switch in the control panel securing it with the 2 screws. Installed the dial, installed the upper back panel using the old screws. Plugged the stove back in and tested it. Note: My new switches shaft was 1/8 of an inch longer so it does put the dial a little further away from the control panel. Wife says: It's OK, don't worry about it.
was more of a job of splicing wires together than anything else. Loved the heat shrink electrical tubing to put over the wires for insulation. used a hair dryer. must buy more of that amazing stuff