This grey OEM dishwasher tub gasket is a 73" grey rubber part that creates a seal around the dishwasher to prevent any water leakage during a cycle. If it's damaged or broken, you'll start seeing wate...
The single rack roller kit comes with one axle/clip and one wheel/roller. The rack wheel is designed to allow the rack of your dishwasher to roll in and out. If the rack will not complete this task, o...
This lower spray arm assembly is a vital component in your dishwasher, responsible for distributing water and detergent throughout the tub during the wash cycle. Its rotating motion ensures thorough c...
This door seal is for dishwashers.
Door seal seals the gap between the opening to the dishwasher tub and the outer edge of the door.
After installing the door seal, shut the dishwasher door and ...
This filter is for dishwashers.
The filter removes food particles and debris from the water to prevent the drain from clogging.
Follow the instructions in the manual when installing this part.
This rail end cap, or dishrack stop clip, is a genuine OEM replacement part for your dishwasher. This part keeps the rack in your dishwasher from sliding out. This is a very easy repair, to complete i...
This heating element helps heat water and dry dishes in your dishwasher. It fits various models from Frigidaire, Kenmore, Crosley, and related brands. Located at the bottom of the tub, it replaces old...
$106.52
In Stock
Questions And Answers for FBD2400KW11B
Ask our experts a question about this model and we'll get back to you as soon as possible!
3 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Elbert
February 14, 2024
THE SPRAY ARM CAME OFF & I DON'T KNOW HOW TPO RECONNECT IT
For model number FBD2400KW11B
Hello Elbert, Thank you for your inquiry. To remove the existing arm assembly, simply grasp the center of it and lift it up so that it unsnaps from your dishwasher. You can check out our Fix app for installation videos and instructions. We hope this helps.
Hello and thank you for writing.
Yes, you can the black door panel is part # PS3490406. We hope this information helps. Please contact us anytime if you require further assistance.
Does not come on when switch is turned. Must hit washer close by the switch or the switch to get it to come on.
For model number FBD2400KW11B
Hello Reggie, thank you for contacting us. We would recommend pulling the switch out with a flat-head screwdriver and checking the wires connected to its prongs. Make sure the connections are intact and the switch, part number PS420418, has no signs of burns. We look forward to hearing from you if you need assistance with placing an order through our 7-days-a-week customer service. We hope this helps!
I removed old tub gasket, which the door presses against to make a seal, and put the new one in. Flat tip screwdriver was used to gently press gasket in.
Over Thanksgiving, the spray arm in my dishwasher apparently popped off and was partially melted. I remounted it inside the dishwasher, but the new hole was on the side of the arm. I think this resulted in water being sprayed directly against the door and not up through the top holes. It flooded my kitchen floor.
The spray arm pops on and off with plastic tabs (?) at the base. You can lightly pry with a butter knife or simply wiggle it off. The new one popped right on. Easiest repair EVER.
