Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Denise
May 23, 2023
MY WALL OVEN IS SHOWING F10 CODE It gets extremely hot & doesnt shut off
For model number EW30EW5CGS6
Hello Denise, thank you for reaching out. The error code F10 indicates that the runaway temperature
has been detected. We recommend replacing the control board, part number PS1991659. Before replacing the control board, make sure the temperature sensor, part number PS16745361, is providing the correct reading. We hope this information helps!
When baking (bottom heat element 22.4 ohm), the temperature doesn't reach the desired settings. Sometimes, after resetting the temperature, it does reach thedesired temperature. Upper heating element works well (14 ohm). Replaced the thermostat, same issue. The soldering in the controller circuit looks good and no signs for burnt components. Connections in main terminal block seems OK. Appreciate letting know what could be the issue.
For model number EW30EW5CGS6
Hello Alex, thank you for the question. We believe your oven is having this problem because of the faulty temperature sensor, part number PS16745361. We hope that helps!
PF alarm appeared on display. Noticed clicking when cord was moved. Had arced for some time and melted original block. New part slightly different. Only has 3 lugs, old one had six. Stack using washers provided. Take note of colors before disassembly. Use caution while working through access opening. The edges are sharp. Only tools needed are phillips screwdriver, deep socket for lug nuts. Nut driver optional. Hope this is helpful.
Repair was quite easy, as long as you have the instructions for removing the door. The screws that hold the bottom of the door to the fixed hinge are placed into the side of the hinge assembly after removal; this holds the door at a 45 degree angle for easy removal. After that, just place the door on a flat surface and dismantle the door from the inside. The inner glass is contained in a metal frame with another piece of glass; this frame comes apart easily using the clips in each side. The door assembles easily after the glass is replaced; just take your time and give yourself enough room to lay out the parts as you go. Good luck!
Had to reference original owner's manual for instruction(s) on how to remove oven door. Used several "YouTube" videos to reference oven door design (Oven door glass is actually several layers of glass.) After completing about 30 mins of research and finding the right square drive bit, the repair went smoothly and without complications. The biggest challenge was researching and understanding what part(s) were needed and how to replace them. It seemed liked a lot of work doing the research however it sure beat a $350 repair bill. It cost me $90 and about 1 1/2 hours of total time. Oven works better than ever, thanks parts select for the part(s) and diagram(s) ...
