CMXGTAMDAXSC Craftsman Trimmer - Overview
Sections of the CMXGTAMDAXSC
[Viewing 2 of 2]
Keep searches simple, eg. "belt" or "pump".
Questions And Answers for CMXGTAMDAXSC
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Denzil
September 14, 2023
the primer pump, when pushing on the primer pump does it act as the fuel pump for the trimmer? the bulb should fill with gas if it is working properly, right? Can the pump part be replaced or does the whole carb assembly need to be replaced?
Thanks.
For model number CMXGTAMDAXSC
Hi Denzil, thank you for reaching out. According to our research, the primer bulb works by creating a vacuum that draws fresh fuel into the intake fuel line. The fuel is then deposited into the carburetor, preparing it to make the perfect fuel-air mixture. The primer bulb comes as a part of the carburetor, part number PS16427166, so you may need to replace the carburetor. We hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
- < Prev
- 1
- Next >
Common Symptoms of the CMXGTAMDAXSC
[Viewing 1 of 1]
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
One of the two fuel lines cracked and leaking
Removed the 6 screws holding the red plastic cover, tank, and the old fuel lines from the carburetor. Placed the new tank in the sunlight for a few minutes to soften the new fuel lines. Then attached the new lines to the carburetor and replaced the cover
Parts Used:
-
Robert from ORANGE, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
6 of 8 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Drive shaft stop spinning
Remove screws from cover insert New parts put everything back together making sure not damage electrical low voltage switch l.
Parts Used:
-
Henry N from DEERFIELD BCH, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:1- 2 hours
3 of 4 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
My old Troy Bilt trimmer head was falling apart
Just screwed it on the machine. Left hand threads.
The new one seems like a quality item. Of course trimmer line came pre-installed, ready to go.
The new one seems like a quality item. Of course trimmer line came pre-installed, ready to go.
Parts Used:
-
david from NORTHFIELD, MA
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
2 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!