This is a genuine OEM sourced replacement housing screw designed for Ryobi and Troy-Bilt trimmers and blowers. It is commonly utilized to secure the starter housing. Please note, this metal housing sc...
This is a genuine manufacturer-sourced component which is specially produced for use with Troy-Bilt, Yard Man and MTD handheld string trimmers. It is an identical replacement for a missing or a faulty...
This is a genuine manufacturer approved replacement drive shaft that is designed for string trimmers. Flexible drive shaft fits inside the drive shaft housing to spin the cutting head. It is made out ...
This is an authentic replacement part, sourced from the original manufacturer for use with trimmers. The special handle connects to the lower end of the shaft and is used to provide an additional grip...
This is an authentic replacement part manufactured for use with outdoor power equipment. The special muffler assembly is used to reduce emissions caused by the release of combustion gasses. This muffl...
Removed the two screws holding the fuel tank to the main unit. Removed the two fuel lines and any stuck on rubber. Installed and installed two screws to mount the new tank. Slid fuel lines on their respective connectors. Done.
The fuel tank is held in place by 2 screws. Simply take the screws off and pull off the fuel lines. Take the new fuel tank. Put it in place and screw the 2 screws in to hold the fuel tank. Connect the fuel lines and you're done. This is the easiest repair I have ever done on any of my lawn equipment.
Drive shaft replacement was very easy . Minimal tools were required. Just disconnect the throttle cable, mainly for easier movement of trigger handle. Then remove the guide handle and the trigger mechanism and base. Reassemble reverse order.
