This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.
If your front-load washer is leaking or making strange noises, this door boot seal might be the fix. It creates a tight seal between the door and the tub to keep water and detergent inside during the ...
Having a problem with a funky-smelling washing machine, or one that just doesn't seem to clean your clothes as well as it used to? Say hello to the Affresh Washing Machine Cleaner by Whirlpool. This p...
Upgrading your laundry room? We can help you save space effortlessly with our Whirlpool Long Vent Dryer Stack Kit. Designed specifically for certain Whirlpool, KitchenAid, Maytag, Jenn-Air, Amana, Ing...
If your washer isn’t draining properly, this water pump could be the fix. It’s the part that helps push water out during the drain cycle, keeping your laundry routine running smoothly. Made to fit sel...
The Leveling leg supports the washing machine. Adjust the height of the levelling leg to make the washer level.
$18.17
In Stock
Questions And Answers for 7MWFW6621HC0
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Luis
May 21, 2024
I'm looking for the Module for this Machine
For model number 7MWFW6621HC0
Hi Luis, thank you for getting in touch. If you are looking for the control module of your model, then the compatible one is part number PS12711816. If you need help placing an order, customer service is open 7 days a week!
We unplugged everything. Then we removed the screws from the back of the washer. Then we slid off the top of the washer. Next, we removed the bottom drawer of the washer. We then proceeded to remove all of the screws and took off the entire face of the washer until the bellow was completely exposed. We did have to detach the hose and door clamp. We removed two metal clamps that held the seal in place. Once those were off we removed the entire old seal, replaced it with the new one, clamped it down, and reversed the steps to put everything back together. It was fairly simple.
Replaced door latch after removing rubber seal from tub to access door latch. Simple replacement but did not correct issue. Notified service technician to determine error codes and had to replaced display panel and control module.
