This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.
Having a problem with a funky-smelling washing machine, or one that just doesn't seem to clean your clothes as well as it used to? Say hello to the Affresh Washing Machine Cleaner by Whirlpool. This p...
Upgrading your laundry room? We can help you save space effortlessly with our Whirlpool Long Vent Dryer Stack Kit. Designed specifically for certain Whirlpool, KitchenAid, Maytag, Jenn-Air, Amana, Ing...
If your washer isn’t draining properly, this water pump could be the fix. It’s the part that helps push water out during the drain cycle, keeping your laundry routine running smoothly. Made to fit sel...
Replaced door latch after removing rubber seal from tub to access door latch. Simple replacement but did not correct issue. Notified service technician to determine error codes and had to replaced display panel and control module.
i had no clue, yet when you you tube it, there are a few ones that are pretty good. Be patient, follow the directions, do not cut any corners or it will leak! The hardest part is putting the front clamp back on, here's how you do it; put the wire clamp on at the top, and pull it around on the left side, then, by using the needle nose pliers, have the wire clamp at about 3:00 o clock on the right, there is a spring on that wire clamp, put that at 3:00 o clock as well, pull down as hard as you can at the spring which stretches the clamp, then work it around with your other hand, or your wife if she isn't scared like mine was
