This is an authentic LG water inlet valve for a top-load washer. It is designed to control the flow of water into the washer. If your washer is filling slowly, making loud noises, overflowing, or stop...
Discover how you can keep your LG washer running like a breeze with our authentic LG Washer Shifter Coupling. This key component enables your washer to transition from agitation to spin cycle smoothly...
This part is the replacement fabric softener cap for your washer. It is also known as the washer dispenser drawer insert. It is made of blue plastic and is approximately 4 1/4 inches by 2 1/4 inches. ...
This washer lid hinge damper assembly helps control the movement of the lid, preventing it from slamming and reducing noise during opening and closing. It’s an easy replacement when the lid feels loos...
If your washer isn’t spinning or agitating like it should, this shift actuator might be the fix. It helps switch between wash and spin modes by connecting the motor to the tub. It’s a common repair an...
We understand your struggle with a malfunctioning washing machine and guess what? The solution might be easier than you think! This LG Washer Detergent Box Assembly could be just what you need. This...
I diagnosed by running a full wash. I watched it and when the water should have stopped it kept running. I unplugged the washer from the power and the water kept running. This told me the inlet valve was the issue and not an electronic issue. I stopped the water by closing the water valve manually. Replacing the inlet valve was very easy. Hardest part is moving the washer out of the laundry room. The videos online show very simple steps. Maybe 8 screws to remove and a couple of hoses and five electronic connectors. Take a photo of connectors before removing them to ensure you reconnect properly.
The problem was the valve suppling water to the bleach dispenser was not closing completely. This also caused some water leaking towards the front of the washer. Replacing the entire valve assembly was very easy. Unplug the washer, turn off the water, remove the 2 screws that attach the control panel, disconnect the water supplies, unplug the 5 solenoids, remove the hose clamps from the 2 hoses, remove the 3 screws that attach the valve assembly and remove it. Reassemble in reverse order, I did find that applying some water based personal lubricant to the 3 high pressure seals made assembly much easier.
