Models > 5871641591 > Parts

5871641591 Kenmore Dishwasher - Parts

Wheel & Bushing Assembly – Part Number: 5304532229

PartSelect #: PS16745479

Manufacturer #: 5304532229

The single rack roller kit comes with one axle/clip and one wheel/roller. The rack wheel is designed to allow the rack of your dishwasher to roll in and out. If the rack will not complete this task, o...

$13.89

Heating Element Brass Nut

★★★★★

(8)

PartSelect #: PS1524878

Manufacturer #: 154106202

This nut is sold individually. It is used to install the heating element.

$16.43

Upper Wheel And Bushing Assembly (Black)

★★★★★

(3)

PartSelect #: PS17219660

Manufacturer #: 5304535381

This is sold individually. Please order quantity required.

$8.82

BASKET

★★★★★

(4)

PartSelect #: PS16218301

Manufacturer #: 5304509753

This is a basket for your dishwasher. It sits in the lower dishrack and holds small utensils during a washing cycle. This basket has six smaller sections where you can separate your cutlery into speci...

$53.22

Upper Dishrack Track End Cap

★★★★★

(1)

PartSelect #: PS452590

Manufacturer #: 5300809927

Sold individually.

$11.28

Door Gasket

★★★★★

(4)

PartSelect #: PS452429

Manufacturer #: 5300809611

This one piece dishwasher door gasket provides a water tight seal to keep water from leaking out of your dishwasher.

Single Door Spring

PartSelect #: PS452475

Manufacturer #: 5300809703

NOTE: Sold individually. This door spring is four and a half inches long. It is used for some dishwashers. These springs tend to wear out at the same rate, so you should replace both of your dishwashe...

$55.76

SCREW

PartSelect #: PS419777

Manufacturer #: 154093301

$7.28

Dishwasher Wash Impeller

PartSelect #: PS452583

Manufacturer #: 5300809918

This electrically operated propeller causes water to flow through your dishwasher's pump. This impeller is located above the dishwasher's mascerator blade.

$98.56

Water Inlet Valve

PartSelect #: PS452425

Manufacturer #: 5300809606

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.