5648946050 Kenmore Refrigerator - Overview
Sections of the 5648946050
[Viewing 4 of 4]
Keep searches simple, eg. "belt" or "pump".
Tub Sound Shield - Insulation
PartSelect #: PS12070612
Manufacturer #: W11086533
If a noisy dishwasher is disturbing your kitchen tranquility, it's time you met our Whirlpool Tub Sound Shield. This simple addition serves as a sound barrier to dampen the operation noise of your dis...
$40.95
In Stock
Order within the next 9 hrs and your part ships today!
Lint Filter
PartSelect #: PS2028956
Manufacturer #: 300838
This filter collects lint as it passes through the dryer vent.
No Longer Available
Dishwasher Upper Spray Arm
PartSelect #: PS11740654
Manufacturer #: WP304204
This spray arm is just underneath your upper rack.
$184.22
Special Order
Water Inlet Valve
PartSelect #: PS11740648
Manufacturer #: WP303650
This water inlet valve is intended for use with under counter style dishwashers. It has a 3/8 of an inch FPT (female pipe thread) valve and a mounting bracket. - This water inlet valve should be loca...
No Longer Available
Questions And Answers for 5648946050
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the 5648946050
[Viewing 1 of 1]
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
One of the 4 latches that holds the spray arm to the top rack broke and fell off.
It just snaps back in but it was a very tight fit and took two people to force it in. Plus I had no instructions and hadn't seen it before it broke so it took a little time to figure out where it was supposed to go. The arm doesn't connected to anything except the rack. I guess water just shoots up into it from below.
Parts Used:
-
Mickey from Novato, CA
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
19 of 26 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dryer of elderly relative was very hot and dried clothes slowly.
The lint filter was torn in a couple of places. This let lint go into the dryer vent pipe over a period of years. I ordered a new lint filter and replaced it. I also pulled out the plastic piece the filter sits against and cleaned out behind it. The vent went to the roof. I pulled off the rain shield and found that the vent pipe was almost completely packed with lint. I pulled out all I could reach and nailed a 2x2 inch and 1x2 inch together and used it to scrape out the vent pipe. I placed a flashlight in the bottom and checked to see it was clean. I replaced the rain shield and carefully reconnected the dryer to the vent. Now the dryer runs cool as it should.
Parts Used:
-
John from Sante Fe, NM
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:More than 2 hours
16 of 27 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Upper Spray Arm broken off
It was so easy , I first put one side of the clamp on the little rack area in the center of the upper rack then pushed the other side on. It took less than five minutes. No tools needed. Julia
Parts Used:
-
Julia from Colorado Springs, CO
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
7 of 10 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!