This hot water inlet valve is designed to regulate water flow into the washing machine during operation. Featuring a standard hose fitting inlet and a single water outlet, it opens as needed to allow ...
$78.09
In Stock
Order within the next 9 hrs and your part ships today!
This washer hose with bellows, also known as a dispenser hose, is a genuine OEM replacement part for your washer. Replacing this part can be helpful if your washer is leaking. The dispenser hose conne...
$63.78
In Stock
Order within the next 9 hrs and your part ships today!
The magnetic door plunger attaches to the inner door panel of your washer and will hold the door open when the washer is not in use and allows the door and tub seal to dry. By doing this it will preve...
$78.50
In Stock
Order within the next 9 hrs and your part ships today!
This round rubber tub seal is designed to prevent water leakage between the front and rear halves of the outer tub in select washing machines. Positioned at the junction of the tub components, it comp...
$43.85
In Stock
Order within the next 9 hrs and your part ships today!
The blue plastic detergent dispenser holds the detergent and then dispenses it into the washer during the wash cycle. If the detergent dispenser is broken, lost, or if the detergent is not dispensed d...
$36.85
In Stock
Order within the next 9 hrs and your part ships today!
This door boot seal is designed to create a watertight barrier between the drum and door of front-load washing machines, helping prevent leaks and maintain efficient operation. Over time, the seal may...
$228.59
In Stock
Order within the next 9 hrs and your part ships today!
Is your LG washing machine not working as efficiently as it used to? It could be due to a faulty wash pump motor. This is the part that keeps the water circulating during the wash cycle, crucial for e...
$172.14
In Stock
Order within the next 9 hrs and your part ships today!
There is a magnet at the bottom of the door which allows the door to be held ajar when the washer is not in use to allow the tub and gaskets to dry. A tab on the plastic housing which retains the magnet broke which allowed the housing to pull free of the door and stick itself to the machine preventing the door to close. Easy fix to replace the magnet was $18. Instructions were included in the box. Part number on the drawing was A165. PS3618292 Magnetic Door Plunger
Pull washer away from wall. Unplug cord and remove drain hose from receptacle. Remove 4 screws holding panel to rear of washer. Squeeze and slide back hose clamps on each end of drain hose and loosen center clamp with screwdriver. Remove old hose. Reinstall new hose in reverse order using existing clamps. Re-install back panel.
