This comes set from the manufacturer for Natural Gas. It also includes the conversion to Liquid Propane.
This valve automatically cuts off the flow of gas at a certain pressure.
This is a replacement drip bowl for your range or oven. The drip bowl sits beneath the burner element and collects any drips or spills. This drip bowl is 8 inches in diameter and is used to replace th...
This burner bowl, also known as a drip pan, is a legitimate OEM replacement part for your stove. Turn off power to the unit when conducting this repair. You will need to unscrew the existing burner bo...
Burner valves are attached to the main gas line. When the switch is turned the gas then flows into a tube that mixes with air, creating the appropriate mixture for combustion.
No Longer Available
Questions And Answers for 36333355590
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Removed the two screws holding the porcelain burner bowl. Disconected the electric igniter by removing the "w" clip on the underside of the bowl. Then disconnected the igniter from the electric supply cord. Reverse these directions using the new urner bowl. Really easy.
Pulled off burner grates, burner, unscrewed burner bowl, removed clip from igniter and wire, then put it all back together. Was very easy, and the stove looks like new again.
PartSelect is very good with amazing shipment times. The kjpart arrived much sooner than expected.
No way to adjust mixer tube assembly so the mounting holes will line up with the holes in the burner bowl. Mounting holes in bowl should be slotted to prevent future problems. Had to finally bend the mixer tube mounting bracket enough to get one bowl on. It also made the procelin break on that bowl because the screw put to much pressure on the side of the hole.
Igighter mounting hole out of position just enough to prevent the burner head from sliding over it and sitting on the mixer tube correctly.
I solved this problem by fileing the opening slot for the igniter. Even with the igniters being just a little out of alignment from the original position they still light well.
I did not get new gaskets for the burner bowl but would reccommend that you get them.
