All Installation Instructions for Craftsman Chainsaw 358381700

Would not start , had been sitting for years,

I did not write detail steps , basically remove old carb replaced with new one, reassembled started right up no adjustments were needed !

Parts Used:

Carburetor

Sherri from BREAUX BRIDGE, LA
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers

11 of 13 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Worn out oil pump/burning chains

After checking several different videos, ordered the repair parts and two specialty tools( Clutch removal/install and a worm drive remover/installer) Total for parts and tools around 45.00. Much cheaper than the shop wanted, 85.00 to look at it plus parts. As for results I've used the chainsaw all afternoon no problem. Runs like it did 12 yrs ago. Pumps oil the would make Jed Clampet proud

Parts Used:

Oil Pump

Gear-worm Spring

William from EVANSVILLE, IN
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Socket set

6 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

My neighbor brought the saw to me. It was locked up

He didn't want to spend alot of money on it. So I got the jug (Head) off and sanded it and the piston down while I waited on the new piston ring to get here. I found that it was easier putting the new ring in and the piston back into the jug (Head) was to go ahead and take the piston out so you could turn the jug (Head) upside down and it slid right in. It didn't take no time at all. And it now runs as good as new

Parts Used: