316711971 (41BDZ41C799) Craftsman Trimmer - Overview
Sections of the 316711971
[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
AIR FILTER
PartSelect #: PS19282843
Manufacturer #: 753-05254
This is an authentic manufacturer-sourced component which is specially designed for Craftsman trimmers. Its purpose is to filter out dust and debris from contaminating the carburetor and engine, unfor...
No Longer Available
FUEL TANK PADS
PartSelect #: PS19282846
Manufacturer #: 753-05259
It is an authentic item that is supplied directly from original equipment manufacturer for use with MTD and Troy-Bilt string trimmer, edgers and backpack blowers. These replacement pads are used to se...
No Longer Available
LOWER DRIVE SHAFT
PartSelect #: PS19282854
Manufacturer #: 753-05267
This is a genuine manufacturer approved replacement drive shaft that is designed for string trimmers. Flexible drive shaft fits inside the drive shaft housing to spin the cutting head. It is made out ...
No Longer Available
O-RING
PartSelect #: PS19283179
Manufacturer #: 753-05902
This is a genuine OEM replacement part. The Troy-Bilt O-ring is constructed of black rubber, and is compatible with a variety of lawn and garden tools. Referring to the specific manual and diagrams fo...
No Longer Available
SCREW
PartSelect #: PS19264550
Manufacturer #: 710-04194
This part is an OEM sourced directly from the manufacturer. It is designed for blowers, trimmers, and edgers made by Troy-Bilt, Ryobi, Yard Man, MTD, and Cub Cadet. The metal star screw fits into vari...
No Longer Available
Questions And Answers for 316711971
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the 316711971
[Viewing 1 of 1]
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
One of the two fuel lines cracked and leaking
Removed the 6 screws holding the red plastic cover, tank, and the old fuel lines from the carburetor. Placed the new tank in the sunlight for a few minutes to soften the new fuel lines. Then attached the new lines to the carburetor and replaced the cover
Parts Used:
-
Robert from ORANGE, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
6 of 8 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Drive shaft stop spinning
Remove screws from cover insert New parts put everything back together making sure not damage electrical low voltage switch l.
Parts Used:
-
Henry N from DEERFIELD BCH, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:1- 2 hours
3 of 4 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!